I needed to mount my new SA plates in a hurry (keen for first drive in quite some time!), the problem is that SA plates aren't pre-drilled for FE/FC Holdens (go figure
)
Drilling mounting holes in the plates to get the plate sitting in a centred position would mean going through the raised letters
No alloy sheet or metal sheet in the garage to make up some adaptors (casualties of moving house).
So, I popped next door to Stratco and got some garden edging, it's about 4-5mm thick and easy to work with. Measured up the rectangular pieces I needed, drilled the lower holes to match the bumper and the upper holes to match the plates, job done
(half of that story is a lie, my son did the fab work, had to make him do one mount twice because it was a couple of mm off
)
