FC front bench seat spacers

[FCRB26]

I have drwan these as accurate as i can from a photo copy the hole centres are perfect on the passenger side floor holes but drivers side is half a hole out???

Also i have a ton of 10mm PVC instead of 12mm $23 a set plus delivery 12mm alloy will be about $44 set but will need numbers before i cut them.


pete

[pedro]

Pete, I've just gone through my bits and I have a good front and a good rear spacer left you can copy off, I'll send them down whith the money for those adaptor plates.
                          Pedro

[stephen]

Hi Pete .. went out to the shed and swapped front spacers left to right, they lined up and bolted down OK, same with the rear spacers both interchangeable and bolt down OK .. looking down thru the hole, each one may be about 1 to 2 mm off center but the holes are bigger than the bolts and fit nice and snug when pulled down .. hope this helps .. Regards Stephen 

[FCRB26]

No worries

Pedro i will Try to get my wheel apart to get the adaptor out worst case it will be on the weekend.

So i should have a set by next week.

[graham_fuller]

56 and 57 Fe's were plywood.
Cheers,
Graham

[FCRB26]

Ok Lady,s and gents
I have a very good original smaple and i will cut a heap of seat spacers tommorow Alloy ones are 12mm grey PVC are 10mm

All spacers are water jet cut absaloutley clean as a whistle cut.
Money back if your not happy with the quality.

Prices as previously posted.


Pete

will post pics of both tommorow night.

[FCRB26]

Also plywood ones if you want or steel i can cut any material spot on.

[FCRB26]

Ok i have 5 sets of 10mm Grey PVC ones in stock $23 plus postage
I also will have sets of 12mm alloy ones in stock next week
please e mail me for bank details and quanitys.
full money back gurantee if you are not happy.

Pete

[FCRB26]

Ok Ladies and gents here we have  the 12mm alloy seat spacers  i have a few sets cut can cut them pretty quick now

Stephen yours will be in the mail monday.

[FCGos]

Got my 10mm PVC spacers today, very neat job