Strippers

[hrpremier]

Just wondering what paint strippers people have used to get there panels back to bare metal.

I know theres the option of soda balsting, sand blasting acid dipping etc but like most due to lack of funds on a regular basis the long and tedious process of paint stripper wins out as my best option at the moment.  Just curious as to the success of some brands over others.  Im expecting to paint strip the best part of it off and then sand back with a disc on a grider whats left. 

Also if used stripper what did you put on the ground to catch all the stripper and paint, just tarps or was cardboard etc a better option.

Luckily the paint is still original and no excess panel damage, resulting in excess paint underneath the top coat.  Thanks to all in advance.


Jase

4869

[colt]

Jase, I used those cheap plastic sheets from supacheap. Their cheap strippers are ok, always better to use when warm.
I always kept a bucket of clean water handy for any nasty little incidents.

Have fun!

Colin.

[TTV6FC]

C'mon,really...how many people are going to admit to having used a cheap stripper....

[hrpremier]

Thanks colin. Job for today. Wife and I are going out to purchase a stripper.  Never thought that would happen although Ive asked many a time. LOL.  About the temp.  Thanks for the heads up but I live in Far north Queensland (Cairns) so lack of temp is rarely a concern unlike ACT.  Im coming your way in June when I bring my car up for the hd/hr nationals so I will find out how cold it can get.  Cheers.

Jase 4869

http://gallery.oldholden.com/hrpremier/

[FX1975]

I used stripper pads on my 7" sander and wire wheels on my 4 1/2" angle grinder and found they worked a treat and cheap too compared to chemical strippers

                                Hope this helps
                                            Frank

[colt]

Jase, heat should'nt be a problem then. An understanding wife is always a bonus. Make sure you bring plenty of jumpers and coats.

Colin.

[pedro]

C'mon,really...how many people are going to admit to having used a cheap stripper

Just thought I'd mention that this has been talked about before on the site so you should be able to look it up, apparently the best technique is to apply the stripper then cover with clingwrap for a while, scrape it off then use one of those seaweed(stripper) discs to take off the rest as they don't generate as much heat and warp panels.
                                                             Pedro

[GMB-58FC]

Depending on how much paint there is to remove i will either use standard stripper which i paint on, the 6" grinder with the stripping/sanding discs or my Dewalt sander.

I used this stuff (think it was made by Selley's) that came in a pressure pack and worked really well but at $12 a can it would work out very expensive to do a whole car