FE-FC Holden Discussion Forum
November 26, 2024, 06:15:49 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: Are you a member of one of the FE-FC Holden Car Clubs of Australia ? If you are, get access to the Club-Member-only area of this discussion board. Send an IM to the board admin, including your real name and club to get access.
 
   Home   Help Search Calendar Login Register  
FE-FC Holden Discussion Forum > Technical Board > Modification Help (Moderators: RET, Glenn 'Stinky' Stankevicius, gp) > Diff Pinion Angle?
Pages: [1]   Go Down
« previous next »
  Add bookmark  |  Print  
Author Topic: Diff Pinion Angle?  (Read 2780 times)
THOMMO_2
Junior Member
**
Offline Offline

Posts: 80


FB-EK Car Club of SA


View Profile
« on: February 25, 2008, 07:40:07 PM »
0
Gday All
Is the pinion angle the same on early holdens, FE to HR?
If so, what is the angle?
Thanks
Jeff
Logged
USE IT OR LOSE IT
FC427
nsw-club
Guru
*****
Offline Offline

Model: FC
Posts: 2457


I love YaBB 1G - SP1!


View Profile
« Reply #1 on: February 25, 2008, 07:50:32 PM »
0
 It is suppose to be the same angle as the back of the gear box if you put a straight edge on the back of the box up and down and a straight edge on the rear yolk up  and down the measurement should be the same top and bottom some say it is good to vary the angle a couple of degrees so it doesn't wear the universals in the same spot but up to you  ......FC427.......
Logged
As I lay rubber down the street I pray for traction I can keep, but if I spin and begin to slide please dear god protect my ride
THOMMO_2
Junior Member
**
Offline Offline

Posts: 80


FB-EK Car Club of SA


View Profile
« Reply #2 on: February 25, 2008, 08:03:34 PM »
0
Thanks FC427
I did know the why's, I just need an angle on a standard diff.
Thanks anyway Wink
Logged
USE IT OR LOSE IT
Pages: [1]   Go Up
  Add bookmark  |  Print  
« previous next »

Share this topic...
In a forum (BBCode) 
In a site/blog (HTML)

 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Valid XHTML 1.0! Valid CSS!
Page created in 0.035 seconds with 20 queries.