News:

Are you a member of one of the FE-FC Holden Car Clubs of Australia ? If you are, get access to the Club-Member-only area of this discussion board. Send an IM to the board admin, including your real name and club to get access.

Main Menu

headlight switch dramas

Started by old59, May 22, 2011, 09:24:52 PM

Previous topic - Next topic

old59

Hi guys i have been tinkering behind the dash and have noticed that when i put the parkers on the headlight switch arcs on a contact that seems to bridge something. it arcs and gets hot then bends away and makes contact again once cool enough repeating the process. does anyone know what this bridge strap is for and what would be causing this drama.

mcl1959

It's a built-in fuse - you have a dead short somewhere in the headlight circuit or in the headlight switch itself - MUST be rectified ASAP.

Ken

old59

thanks for that will be looking into it tonight. :-\

FCRB26

For how pimitive it is it works well.

Better than driving to work one day the whole car filled with smoke the .22 calibre shells for fuses did not work real well smoked the whole harness..

old59

Quote from: mcl1959 on May 22, 2011, 09:41:31 PM
It's a built-in fuse - you have a dead short somewhere in the headlight circuit or in the headlight switch itself - MUST be rectified ASAP.

Ken
All sorted you were spot on dead short in the front right parker Thanks for the help.

KFH

Good that you found the fault easily.  The same principal is still used for circuit protection today in the form of self resetting breakers.  These are availavle in a range starting at 20 amps and cost less than $10.  If the one of the headlight switch is a bit dodgy it would be a simple matter to bend the spring contact out of the way and wire a modern one across the terminals that the old one bridged.

Keith
I was born with nothing and still have most of it left