This what I did for the front of mine

Sent from my CPH1725 using Tapatalk

I can't see anything might be me

looked at stark and they look great and priced well.

have seen a number of inner sill suppliers and varying prices, can anyone recommend a supplier or suppliers for these that would be great,I have a wagon
cheers
Corey

no problem great to see you got there in the end.

cheers Corey

Hi Vern,
I have taken some photos and will send have four rims with tyres on them so I can't check the stamping but have the triangular stamping.

Cheers
Corey

rob
some have yoga, some have meditation. Like you I have my FC. it has been great and encouraging to see this journey from the start. look forward to seeing more.

Cheers Corey

you have done a nice job, patience is definitely the key.

looks great and would make an awesome ratrod.

Corey

I knew inevitably that I would have to tackle the front A pillar bottoms. They seemed OK originally, however once I put the wire brush to them, they fell apart.  Luckily, inside was in good condition, it was only the outside that needed fabricating. Like a jigsaw, old removed, new built up piece by piece, job done. Plenty of rust converter and rustproofing sprayed inside though!








from the look of the panels are they from a donor car or have you fab them as I'm trying to find a wreck to cut both sides off. I feel spoilt looking at yours as I only have minimal rust but it had to be in that spot

cheers corey

mate looks great am about to start the same job and have been looking at the best way to go about it.and came up with the same system as you.
cheers
Corey

wow now that's a chop! looks awesome can't wait to see more.
Corey

the wealth of knowledge here is amazing, and you would be a fool not to take it on board, and ask questions.v6 conversion offer a 5.0 conversion kit which includes wiring and speedo kits has anyone used or seen them and how do they compare to CRS chassis kits?

have also read injectedv8 build and I think that path is worth further exploring ,my aim is to keep the paint and exterior untouched as I think it tells a story of its history.
 

Thanks jb have read it a few times and the results speak for itself the ute looks awesome.especially the kelpie!  A rotisserie do you know of one that some one would sell or some basic diagrams for me to make one. I was looking at the chassis kits from v6 conversions have you heard about these.

Hi all have spoken to a few people already on forum, thanks to all for getting me here.Plan is to convert to v8, currently have a Vs ss ute as conversion vehicle have owned this since new and now needs a good home. Have been looking at the conversion kits that are on the market I look forward to hearing thoughts on these.

The start.


hoping not to change to much want to keep it looking original as possible, but drive train and safety.

Cheers
Corey

If you get stuck, email me the photo's and I will put them up for you

Cheers, Graeme

Thanks very much for the help will post more pics and info on plans for the wagon, again thanks Graeme.

Cheers
Corey

hope this works

Cheers mate, will see how all works out and photos up soon.

Trying to post a picture.

how do you put a file onto the forum? I have tried clicking on the photo in the message icon area, but not uploading. It there a trick?

Thanks