I have an Fc gear knob with the metal end it in good condition but don,t know what it is worth as I want to sell it any Ideas Thanks Michael

I had the same thing with my FC and found the hand brake cable was shorting on the dip switch
Michael

I emailed them to get a photo with the lid up but it dosen't have one as they wanted a white roof as it had a black oneso they took it offand all that's there is the frame so you had to get a top done to finish it looked great though Michael

All my friends that come over see my car in the garageand ask how the HAW is going I don't know if its short for my footy team or what Michael   HAW 994

FCEE
I ask the same Question and Ken told me 300mm from the front edge of the bonnet I used my wifes sewing tape cos it is flexible stuck down tissue paper marked the holes checked twice and checked again then drilled again .My car didn't have a bonnet emblem and it is quite scary drilling holes in your car Michael

Hello every one
I have a Yellow & Black FC model still  in the box for sale to anyone that is interested I bought it off ebay for $75.00 and that's what I'm asking for it . The reason I'm selling is that I bought one in Tassie at the same time as being the winning bid.So if your interested send me an email mjdenny@bigpond .com
                                           M Denny

Did you notice the grill and indicators are painted on I had to look twice  Michael

Hi Mark
          I had the same problem just replace you wheel studs with longer studs and go to any tyre and wheel place and buy a set of spacers.They come in different widths from 3mm to 10mm they're about 15 bucks each
  Michael

Great pics Craig
Did you notice the dual wheels on the Fb campervan also did you see the Sandman panel van. The green eh was well done too thanks again  Michael

Hey Richard
Put it in the cupboard and leave it there as it will be worth a fortune in years to come , go shopping and buy him his first HRT racing car coz they're red and go faster .
And at least it's a HOLDEN  
                                            Michael

Seasons Greetings to all members and thank you to Ret & Ken for the entertaing reading this past year. Also to everyone who helped with replies to FAQs about our cars . A safe and trouble free year to everybody Michael

Your dead right Slim I had the same thing sitting at home it's to stop the water from getting into the electrics  Michael

Hi Terry My Fc did exactly what yours is doing and my flexible hoses were clogged with black rubbery crapp. I replaced the and the brakes were fine after that . Michael

Hi Michael
I ground the rivets off with the angle grinder punched them out. Then with a 1/2 inch drill ,drill the 3spot welds
out I did the same with the eh crossmember then had it welded to hr crossmember but don't forget the fc sway bar will need to be changed also ek fits perfectly or get a new one made  hope that helps  Michael

Ken you told me that you asked them to do a twin pack with the 2 colours reversed Tan with white roof and white with tan roof.  I think that is pretty close to becoming an Fe Poo mobile

 Hi guys can any one tell me where you can get 13x6whitewalls from. Does any make them still or do you have to get them cut in

Hi guys I was talking to Ken at our xmas run and they are definitely doing the Fe. He also  suggested what colors would be the best for the models So hang in there they shouldn't be to much longer

Hi Weedy That would be great my Email address is
mjdenny@bigpond.com Thanks Michael

Hi Weedy could you tell me what you did to widen the tunnel to suit a trimatic as I want to do this to my sedan I'm trying to find the best way to do it   Thanks Michael

Fc are better. Fe are to plain need chrome you can tell an Fc a mile away by the sun glare off all the chrome as it drives towards you plus everyone knows the second model is always better