Thank you all for your comments , for a novice like me I really appreciate your advise. it is the wind lace ( new term for me ) Black with silver thread through is probably what it was new- now dirty mix colour of these. Again sincere thanks , sorry for late reply as have been away. Curlslinc

Hi all, has anyone got a spare/surplus piece say 40-50 cm long of the the cloth with the rubber underneath that fits around the inside of doors on a FC. Colour is the white-grey with flecks. My trim is tan/black . Am wanting to replace the damaged piece on the bottom where goes onto floor near bottom front door hinge ? Thanks in advance.

Jim , thanks a lot for your guidance, will do it as you recommend.

Thanks for prompt reply, yes it is coming in over the rubber or in between rubber and glass , so was thinking of pushing nozzle in as you suggested.

Hi all , what else holds in place the chrome strip at bottom of windscreen besides the two screws. I have water leaking into dashboard via one corner where I suspect more sealant needs to be "pushed in " under the good condition rubber seal . any suggestions please ? Curly

Please all note this FC sedan has been sold.

Selling my FC  , the 37,766th manufactured  due to lack of garage space.Original two tone grey paint. Drives  very well, totally reliable. I use it on weekends around town & short country drives.Located in Toowoomba , Q'Ld . Been garaged past 12 years, the grey motor has been fully overhauled in May 2011, brakes, suspension, steering is perfect as is gear box-clutch. Tyres as new. Both seats re-covered 3 months ago. All rubbers, seals,window channels been replaced 10 months ago; original paint is in good condition , very mininal surface rust. However the roof lining needs replacing. Price $16000 o.n.o.

Hi , I have an FC special for sale. you can find full details/photos in Carsales.com.au However you can email direct if you want more details.

Thanks for all the replies , some sound suggestions--seems like I will loose plenty of skin trying to put it back. Curlslinc

Hi all , any ideas on how to install - how does that back plate hold the cylinder lock in place, tricky holding with your finger !

Tanks all for the three replies last night , good for a new member like me to read back through older articles on subject. I will "try/test " my local agent for Rares ans see if they have one from second batch.

Hi , am trying to source a " black plastic anti-reflecting cowling cover for over instruments "

Hi all ,am chasing both LH and RH ties , what are my chances of buying ones in good condition ? Both are badly worn and beyond re-building !

ONE for my FC please , Curlslinc

Hi , nearly 12 months since you listed this book , is it still available ? Curlslinc

Thanks Ken , yes will buy both . I can tfr pyt plus postage to your bank a/c ? Regards .

Hi All , I am new to this "hobby" Any suggestion on how /where to obtain these  in S/E Qld.

Am new to this scene , have just purchased an FC in original condition , needs lot of TLC . Any contacts for S/E Q'ld area to have work carried out would be appreciated.

Hi , have you had any luck in obtaining this ? , I too am looking for same ! Curslinc