thanks for the ideas will do that

hi thanks no i dont need shifter on column as i have floor shift just need to get wheel away from big gut and the shaft  keeps poping out of joint where bolt goes thru very scary steering wheel spinning so i am tossing steering to try some other way

hi all  does anybody know of a coloum that will suit a front mount rack i have a standard modified fc in it but is to far from dash i was thinking vl commodore any tips thanks john

thank you for the replys will give them a ring

hi all does anyone know where to buy the rubbers that go under the wipers near cowel rares dont sell these thanks john

thank you stinky  will try   john

hi all  am after the left and right front door rubbers for my fc sedan drove it in the rain the other day and more water inside than out from top of both doors i have heard rare spares arnt real good any ideas where to buy thanks  john

thanks all
                    missed it by that much

thank you  the shaft has been set up for the original steering wheel so i am thinking of slotting it down another tube so i will look at the torana thanks

hi
  can anyone help me with an answer to which steering coloum to run with a v6 rack and pinion setup, at the time i am using the standard setup being  original tube with a commodore shaft down to the  intermediate shaft  my question can i use commodore or hq tube or anything that will look nice instead of this setup which sticks out to far and is easy to do which will give me indiactors,horn etc. any ideas thanks john

thanks folks i will try shops,sorry about lateness as i have had trouble with my computer  thanks again john   

hi does anybody have a sports steering wheel and boss kit to suit early holden thanks  john

thanks for the help craig, rod did my car but i have  removed auto from coloum and put in floor shift and i want to run a small wheel which leaves a gap between wheel and indicators i had to remove horn so it would go over spline i might have to get  something machined   life not made to be easy    thanks again john

pm sent for both thanks john

hi i need all horn parts from indicator to steering wheel on coloum thanks john

hi i need radiator support panel for fc will pay costs to brisbane thanks  john

hi all i have a original steering column that has a vn shaft down the middle for the rack  as i am running v6 does anybody know of a steering wheel that might fit have tried sports wheel with a long boss but it still leaves a gap between end of boss and indicators looks bad can anyone help thanks     john

hi all
          does anybody remember who was asking for interest in getting new linings in original colours,i put my hand up but didn't hear anything is it still a goer trim 350-633 light green i think thats the correct number thanks

thanks for that i will try and take some more pics. here are a couple more for now

hi all here is apic of my fc that i have owned for about 17years bought from next door neighbours estate after it had sat in his garage unrego for 11years after his death. started to strip it down and then lost my job so could not finish job.my neighbour from across the road wanted it so we did the deal as i thought its better for someone to finish then we moved away and about 5years later phone call from neighbour asking if i want it back as his daughter is driving and needed car space so back it came all complete.i have since gone the v6 commodore way as i was sick of it overheating with the sideplate,it now has v6 4wheel discs rack and pinion etc but i keeped all the original stuff just in case.the only thing i am not happy with was the choise of colour it a volvo green not original light green