FC Ute Y frame complete front rust repaired and ready to go straight on

as fitted to my FC Ute project, I have had a change of plans and no longer need this item

item are located in Wanniassa ACT

I have of photos i can email them if your interested or you can call Trevor on 0419203122 for additional information, cheers

07 Dec 2011 Items sold thanks

Hi everyone I have replaced the upper and lower ball joints, spings and shockies on the Hr front end of my FC Ute project and find the wheels are extremely difficult to turn from side to side as in steering, would that be because they are new or have I installed them incorrectly or done something wrong? any advise is appreciated, Cheers

Thanks for the tips on two pack Mark & Ed, I've done a few laquer paint jobs and a couple in enamel but I've never tackled two pack before, I'm going to give it a go because i like the high gloss finish that is achievable compared to laquer, should i buy a proper gun or is my old gun good enough, if it's going to make a difference i'd rather go the extra $ and get the right one.

G'day utesrule66, are the doors not fitting horizontally or verticaly, or is it in or out, hinges can be bent, holes lenthend but if the opening is too small you have problems, I learned the hard way I bought a wagon project once that someone had already started, the doors wouldn't even fit the openings at all, it was easier just to sell it on than to try and fix it.
                   Pedro


Hi Pedro
I'll take some photos and post them for some advise on ways to fix the problem I have come this far now can't quit, I will have to fix it. thanks

Hi, Smart move leaving the doors on I made the mistake of taking them off and now that the floor has been replaced in my ute I can't get the dam doors to line up again. any tips on how i might rectify this? cheers - utesrule66

P.S our intension is to do a V6 change over with a VN or VP commodore running gear

Hi all finally getting around to putting something on this forum about our FC Ute project. been a bit slack at the progress since we bought them in 2006. but most of the time I feel like I have no idea what I'm doing.

My son and I purchased 2 FC Ute's from a nice bloke out at Dubbo
both unfortunately have extensive rust. but we like a good challenge.

we were in Sydney but have now move to the ACT.

will add some photos when I work out how to do that.

[ or ask RET to do it ]