G,Day Ken

Many thanks  PM sent.

George

G,Day Guys

If anyone can help, I,m looking for a pair of the stainless mouldings that fit to the lower seat corners on FC.
I thought that I had them, but it turns out they are from an FB.

Many thanks.  George

Thanks for the input guys. I will give Antique Tyres a ring and see how I go.

Cheers  George

Hi Guys

Could anyone advise a good place in Syd area to buy 640x13in crossplys &
Flappers (Wide type)

Cheers  George

G,Day Dean

I,d be interested in this.  PM sent

George

 

G,Day Guys

(Wish List For My FC)
Looking for a pair of dash switch bezels and a glass washer bottle with or without holder for FC.

Thanks  George

HI All

I,ts a grey motor I think the head is EJ. The springs with the caps on are the correct specs.

Thanks George

Hi Guys

The shop manual gives specs for valve springs as, free length 2.211 in approx.
Does this measurement include the spring cap ?

Cheers  George

Hi Alex

I doubt if Syd would still be alive today, as he was about 60YO back then. However I will try and track down Peter, see what info I can find out and I,ll post it.

Cheers George

G,Day Guys

WHAT A BLAST FROM THE PAST

I remember this car, I used to work with Peters father (Old Syd Brackenridge) and I recall Syd Bringing it into work one day. If my memory serves me right, it was 1968 and Peter was an apprentice Panel Beater, or he may have just finished his time. I can recall that the radio ant was recessed into the l/h/f/ guard and it had a custom roof lining, also it had a red motor, which was not uncommon at the time, however this one was not cramped (lengthwise) and I can recall Syd saying that Peter had extended the length of the front end. On reflection this would have been a major custom. My most vived recollection was and still is that I was very envious and most impressed.  Now that I am restoring an FC, I was only thinking about this very car a few days ago 

I,ts great to see that it is still surviving after 40 years.

Rgds George

Hi Cruiser056

PM sent

Rgds Mudgee

Hi Guys

I,m looking for recommendations on a good upholsterer in the Sydney area, can anyone help ?

Rgds Mudgee

Hi Guys

I,m a bit concerned about fitting the old riveted rims to my FC. I was wondering about welding along the joints for added strength, has anyone done this or could it cause a problem that I cant see ?

Rgds Mudgee

Hi Guys

Looking for a couple of W/screen washer jets (nozzles) if anyone can help or perhaps someone knows of a good substitute ?

Rgds Mudgee

Hi Ken

You are a mine of info. My car comes close to the end, being 67881S. To bad I dont have the original engine.

Regards Mudgee

Hi guys

Can anyone tell me at what chassis number the FC,s finished ?.

Thanks & Rgds
Mudgee

Hi FC427

Thanks heaps for yr reply, I,ve done a deal with mcl1959. If anyone does have info on the guy you were referring to it would be most welcome.


Regards Mudgee

Hi Ken

Thanks for yr reply and accepted with gratitude, will send a PM.


Regards Mudgee

Hi Guys

Looking for a set of Hold Open Springs for the front door hinges or Hinges complete with springs for my FC. On the FB/EK although the hinges are different the springs are the same, so a set of complete hinges for these would get me out  of trouble if anyone can help.

Cheers Mudgee 

Hi Guys
I,m looking for an Air Chief Radio suit FC.  Any condition as I Just need the case and a few other bits. Can anyone help ?

Cheers Mudgee