Did a bit on Saturday. Today was a bit of a right off after staying up to watch Cadel create history at the tour de France.
Managed to make up a floor pan section that will finish the inside section of the drivers side.
So have gone from this
Making new piece up for the sub frame attachment point
Trial fit.
Weld in place and fit floor pan section
fix up bottom of A pillar support
to this
Next job is to fix up the rear secrion of the inner sill then do the other side to up this point.
Now HERE IS MY dilema
Next my intention is to get the subframe sandblasted and coated with KBS. Fit the subframe so that I can finish off the outer section of the bottom of the apillar to ensure a correct fit, as I need to get it off the rotisserie to fit the outer sill
cos i cant fit the doors with the support in place across the door frame!
I would like to get the underside sandblasted too but I don't think I'll be able to get it out of my garage on the rotisserie. It's got a huge slope on the driveway and a car trailer would not be able to make the gradient?? Maybe a flattop.!! car carrier. Any advice please