pm sent Dave

So it does   Thanks Ken,Weddo      Dave

thanks weddo    yeah the cut outs line up with the holes for mounting the guard. what does this piece do and why is'nt there one on the drivers side?    dave

G'day everyone  putting the front panels back on my FE and I have a spare piece that I can't remenber where it goes. I'ts a 595mm long piece of angle 35mm x 25mm with 4 cut outs where it looks like screws or bolts go. I think it goes around the radiator somewhere but stuffed if I can figure out where to  put it. Any help most welcome   thanks Dave

g'day Azz they are the clear ones as I said 1 is very clear with just a little crazing and 1 just a little yellowed by sun damage   Dave

 FE or FC ?  I have 2 FE original lucas lenses 1 is very clear and very little crazing and 1 is a little yellowed.  Dave

Thanks Craig   the pics should help me alot   I HOPE   Dave

Hi all if someone could post a few photos that would be great. Cause I chucked my old rubbers away. Probalbly should'nt have eh!  Dave

Thanks Ken that's what I thought    Dave

Hey Ken the headlining and front and rear screens are going in this week.If we put the rear screen in without any trim would we be able to install the trim later (if I have to get a large trim)   Thanks Dave

thanks Ken It does seem to be a tricky one. I thought I may be able to make up some kind of metal clip that I could sikaflex into the groove in the rubber and then use the original clips and trim?  Dave

Hi all I am getting my front and rear screans ready to install. When I got the rear rubber out of the packet I found something that I did'nt think about, my FE is an early model with the small s/s trim around the back window held in by small clips. The rubber is made for the later and FC trim. Anybody encounted this before or have any way around it. I would like to keep the small trim as A. I want to keep it original and B. I don't have the other trim.  Any advice most welcome. My car was painted this morning I'll have to put up some photos this week.    Thanks Dave

g'day Wayne I'm in northern NSW and am going to Brisbane week after next to pick up some other parts (if there ready) so if you could help out that would be great.  send me a  P.M   thanks Dave

hi all  i am chasing 2 fe fc hubcaps. not too dented and decent chrome will pay good money for some good ones!  thanks dave

thanks Ken   Dave

hey Ken just about to reinstall my speedo . what should I lube it with and which bits. I have a new cable to go in  Thanks Dave

thanks guys. A can of rubber magic came wih my rubber kit so I'll be using this. any other tips?   Dave

Hi all   my FE be out of the paint shop next week and the reasembly starting. i was wondering if anyone has some tips re. fitting new rubbers. I was wondering mostly about the door rubbers were they go over the hinges, what is the easiest way to get them in the correct position? Any  advise about fitting any rubbers most welcome   Thanks Dave

thanks guys   I found some on ebay, the mob selling them say they have 2 sizes  10 1/2" and  9 5/32"  OD  I asked them if they knew if they would fit but all they told me was these outside measurements. Any ideas?  I measured an original hubcap and they are about        9  1/8" on the inside.   Dave

g'day everyone anyone know where I can buy a set of baby moon caps to suit 13" wheels   thanks Dave