|
Title: scuff plates? Post by: NES304 on September 12, 2006, 12:35:07 AM looking for a decent set of Scuff plates (part that runs along sill of body under where door closes)
Title: Re: scuff plates? Post by: Russ on September 12, 2006, 01:22:17 AM I have a FC in vic I dont know what the plates are like but i can find out if you want. (im in Darwin, cars in Bendigo) its the car i bought of mark (minifcvan) he might know what they were like?
Title: Re: scuff plates? Post by: Brad on September 12, 2006, 02:53:01 AM I think Slim was selling some of these a while ago in parts for sale .
Brad Title: Re: scuff plates? Post by: RET on September 12, 2006, 03:48:34 AM Rare Spares sell repro FC scuff plates (but not FE - WAIT, YES THEY DO, FRONT ONLY! Amazing what you find when you do some research...)
FC items: DSP1009 - DSP1012, plus DSS1001 (full set screws) FE LHF: DSP1015, RHF DSP1014 cheers RET Title: Re: scuff plates? Post by: NES304 on September 13, 2006, 12:32:33 AM cheers RET.... I'll give em a call
Russ, I'll try rares but if you find out they're in good nick then i'll knock off yours.... i'll wait to buy from either of you till you get back to me. The ones I have are just to much effort and i'd like an easier job! Title: Re: scuff plates? Post by: Russ on September 14, 2006, 08:55:07 AM The father in law had a look tonight (in the dark) he says "they're all there" but the left side needs re doing, He didn't see any rust but will have a closer look in the daylight
Title: Re: scuff plates? Post by: NES304 on September 15, 2006, 05:15:02 AM what colour were these originally....Chrome or body colour?
Title: Re: scuff plates? Post by: mcl1959 on September 15, 2006, 06:23:43 AM Neither, they were Cadmium plated which is a dull silver colour. Same finish as bonnet hinges etc.
Regards Ken Title: Re: scuff plates? Post by: NES304 on September 15, 2006, 07:39:37 AM looks like I get a choice then
Title: Re: scuff plates? Post by: NES304 on September 19, 2006, 06:48:38 AM (http://i9.tinypic.com/33l2kbm.jpg)
managed to pick these up for less than a carton and they looked like they had cancer everywhere. You can see the one that I haven't touched. Ran em over the sander and they came up pretty good. I think they'll look good chromed had one with a pin hole of rust though in the drivers side rear, so if any one has a cheap one laying around... |