|
Title: Rebuilding HR Front End (Part 2) Post by: Glenn 'Stinky' Stankevicius on October 15, 2004, 11:18:55 PM Just getting a shopping list together for my next Rare Spares visit and I have a question about bush kits.
The upper and lower arm bushes appear to be fine, when I stripped the front-end they were tight and there was no play in them. The rubbers are cactus though. So my question, is it absolutely necessary to replace the bushes? or is it OK to re-use them if there is no play? Title: Re: Rebuilding HR Front End (Part 2) Post by: Blown_FC on October 16, 2004, 12:36:06 AM Stinky....if it aint broke, don't fix it !
Replace them if you want ( if you can ), but if they are fine, then there is no real need to waste money. Did you find out about the Bonnet Pin / Spring assembly ? Cheers Mark Title: Re: Rebuilding HR Front End (Part 2) Post by: Glenn 'Stinky' Stankevicius on October 16, 2004, 01:06:11 AM Thanks Mark, I'd rather not spend the money if I don't have to, just wanted to make sure it was safe though.
I have only had a quick look at the spring, been flat out all week and it's been dark by the time I get home. Got a post-it note on the PC so I won't forget, I'll have a look on Sat and let you know. Title: Re: Rebuilding HR Front End (Part 2) Post by: Blown_FC on October 16, 2004, 02:43:11 AM Thanks Stinky...I've also got a call in to SLIM, so if yours is no good, then hopefully SLim can help out !
Thanks again Mark Title: Re: Rebuilding HR Front End (Part 2) Post by: classicfc on October 30, 2004, 07:02:11 AM ???
The question has to be asked. The bushes are fine so can we get the rubber grease cap/seals only??? Title: Re: Rebuilding HR Front End (Part 2) Post by: RUBBLE on October 30, 2004, 07:47:17 AM hey classic ;)
yes you can just buy the grease seals,i just brought a full set from rare spares for about$16.00. cheers rubble 8) |