|
Title: diff Post by: nicko on June 11, 2004, 07:41:56 AM hi,hoping someone can help with diff changeover,
i want to put a 3.55 ratio centre in and when i looked under Hui (my FE) i noticed they use different join to pinion ,looks like steel cap over uni's bolted to flange where as the later cars have two u bolts holding it in place,can i just change centre and use original cap or do i need to change uni on tail shaft? any help greatly appreciated. reguards Nicko Title: Re: diff Post by: cruiser056 on June 11, 2004, 08:10:45 AM Nicko
You will need to use a uni joint suitable for later model holdens e.g. EH or HR. The new uni joint will fit onto your tail shaft, you just have to get the u bolts. Michael Title: Re: diff Post by: nicko on June 11, 2004, 11:05:23 AM too easy,thanks
Title: Re: diff Post by: gp on June 16, 2004, 04:23:36 AM If you go to your local Holden dealer you should be able to get a uni joint (Part No. M1773), 2 U-bolts (P/N 7422734), 4 nuts (P/N 137508), and 2 lock plates (P/N 7422733). You should be able to get the whole lot for about $50 - $60.
Hope this helps, Cheers, Graham :) Title: Re: diff Post by: nicko on June 16, 2004, 04:26:35 AM thanks for part numbers Graham ,luckily i have a set of ubolts for early holden already so just have to get down town and pick up uni.
reguards Nicko |