FE-FC Holden Discussion Forum

General => General Board => Topic started by: parry on February 01, 2021, 07:24:02 PM



Title: Wind lacing
Post by: parry on February 01, 2021, 07:24:02 PM
I have a fc wagon can anyone tell me the amount of wind lacing required  does it go all the way around the roof linking does anyone have interior photos of where the wind lacing goes thanks Steven


Sent from my iPhone using Tapatalk


Title: Re: Wind lacing
Post by: zulu on February 02, 2021, 04:28:32 PM
Steven,
Pictures attached, when you measure/ cut allow an extra couple of inches where it goes under each end of the scuff plates

Gary

(https://i.postimg.cc/0K53X4VD/20210202-161659.jpg) ($2)

(https://i.postimg.cc/jWV1Y28s/20210202-161649.jpg) ($2)


Title: Re: Wind lacing
Post by: Glenn 'Stinky' Stankevicius on February 02, 2021, 06:05:07 PM
I wasn't sure if wind lace was used in the cargo area and now I know, each door opening takes about 1.7 metres so I generally sell 8 metre lots to do a Sedan (and now Station Sedans).


Title: Re: Wind lacing
Post by: zulu on February 02, 2021, 06:31:52 PM
Stinky,
Not sure how much difference it makes, probably not a lot, but the Station Sedan rear door is square at the back top corner unlike the sedan which is rounded


Title: Re: Wind lacing
Post by: parry on February 02, 2021, 06:48:31 PM
Thanks for the info this will help a lot
Steven P