|
Title: front wheel camber Post by: Fraze on July 09, 2016, 03:44:23 PM My FC sedan has a standard front suspension. I has been suggested to me that a slight ammount of negative camber will lighten the steering (?). Has anyone experimented with camber angles? I would like to reduce the steering effort on my car without comproising tracking. Any suggestions? Thanks, Fraze
Title: Re: front wheel camber Post by: detective on July 10, 2016, 07:27:45 PM All the Holdens have positive camber built into the settings....best for normal day to day operations. The castor settings will definitely make a difference to your lightness of steering....make sure the isolating rubbers are of the correct description and torqued down to the proper "crush". Also be sure the extension engine mount tongue hasn't been bent at any time in the past, as this will "throw" the crossmember and can upset the castor angle....
Title: Re: front wheel camber Post by: mcl1959 on July 10, 2016, 08:30:20 PM Yes I agree, castor is what lightens the steering.
Most old school front end shops that know a little about old Holdens tend to agree that slightly more castor than what was originally specified in the manual gives a better road response. Ken Title: Re: front wheel camber Post by: Errol62 on July 10, 2016, 09:53:49 PM My thoughts too. Increasing castor increases the scrub radius leading to better tracking at speed but heavier steering noticeable at parking speed.
Increasing camber will improve handling and even out tyre wear under hard cornering. Sent from my iPhone using Tapatalk Title: Re: front wheel camber Post by: Fraze on July 11, 2016, 07:35:28 AM Thanks for the responses. I checked the castor on my car and it is right on spec. I am loath to reduce this angle to lighten steering as the trade off with tracking is not worth it. I couldn't see how a camber change (from spec) could lighten steering but thought I would ask the question. I think I will just inflate the tyres higher! Thanks, Fraze
Title: Re: front wheel camber Post by: hsv-001 on July 11, 2016, 02:18:15 PM Ha ha . Not getting involved in this one . I spent many years playing with these specs . Specs were different because roads were different ,tyres were different . We have little nos equipment to utilise . It is not difficult to set the front end close to original then trial and error from there using a variety of road surfaces and conditions . Best of luck .Haydn
Title: Re: front wheel camber Post by: mcl1959 on July 11, 2016, 04:55:05 PM The way I understand it is that crossplys are easier to steer than radials so you increase the castor angle by about 2 degrees to compensate.
This has worked for me in the past. Ken |