FE-FC Holden Discussion Forum

Technical Board => General Technical => Topic started by: smithy on July 14, 2003, 12:16:33 PM



Title: door rubbers
Post by: smithy on July 14, 2003, 12:16:33 PM
hi all im hoping some one out there might be able to help me,
as i purchased my FC sometime ago as an unfinnished project it came with a complete new rubber kit (rare spares) still bagged and labled but alas no instructions and no rubbers were fitted to the vehicle for me to see how the new ones were to go. ???
my question is could some one please supply me with either photos of the door jambs front and rear showing position of rubbers or at least directions on how to fit them. i have also found two small, flat thin rubber strips in a bag marked door inner, these are about 10 cm long from memory and about 3-5 cm wide (where oh where do these go?) i have read back through a couple of posts and got some information but to see it in detail would be ideal.
im hoping this does not sound too silly a question
any help or suggestions would be greatly appreciated
thanks heaps
smithy


Title: Re: door rubbers
Post by: Effie C on July 14, 2003, 07:38:00 PM
Smithy
Do one better, see you are in ACT area, send me your Phone number and can arrange to show you whole car with rubbers fitted.
John M


Title: Re: door rubbers
Post by: smithy on July 16, 2003, 02:24:52 AM
john, your a champ ;D.
i'll send you a pm
dean