FE-FC Holden Discussion Forum

General => General Board => Topic started by: fcwrangler on April 28, 2015, 05:32:00 PM



Title: Can't find it
Post by: fcwrangler on April 28, 2015, 05:32:00 PM
Some time ago there was a post about two small cup head bolts that could not be identified. They were chrome slotted head with a flat washer type barrier then the thread, some suggested they fitted the cowl vent, others the vent handle rod. I think I have just found out what they are for! I can't for the life of me find the original thread so if someone can find it and post it, I'll see if my theory is correct.
Jim


Title: Re: Can't find it
Post by: JOX515 on April 28, 2015, 05:47:26 PM
Jim,

The post is called "Where do these bits go" and is in General Technical.....

Cheers, Graeme


Title: Re: Can't find it
Post by: JOX515 on April 28, 2015, 05:48:43 PM
On page 3, about 2/3rd's way down and thread started by KFH. 


Title: Re: Can't find it
Post by: fcwrangler on April 28, 2015, 06:09:06 PM
Thanks Graeme, just had a look but alas, it's not what I had in mind. While checking parts for the doors, I came across similar bolts from the rear door remote lock tab pivot. These bolts have a slot in the head and the round washer segment is not flattened and only half the thickness.
Jim