|
Title: Panelvan rear seat Post by: slim on June 24, 2003, 09:46:10 AM When it comes to going on club outings A 3 seater is not cutting it for me , So if anyone has an original type rear seat to suit an fc panel van, I believe its a fold down type , Please contact Slim 0402465768 in Sydney . Also to have one of these fitted do you enter for seating through the rear gate or did the front seat perhaps fold forward allowing an entry point . If so I require A folding front bench also . Any help is much appreciated .
Title: Re: Panelvan rear seat Post by: fc_ute on June 24, 2003, 12:37:23 PM would a station wagon seat do?
you would probably have to trim the sides of the extra reinforcement parts of the floor(where the flat van floor runs over where the seat used to go) craig Title: Re: Panelvan rear seat Post by: mcl1959 on June 26, 2003, 07:40:54 AM Slim, wagon seat is the go - it bolts straight in because the van has the same floor pan underneath as the wagon.
You can enter whichever way you like. Or add a third door also from a wagon. This is how the original 3-door vanettes were built. Ken Title: Re: Panelvan rear seat Post by: fcwgn on July 02, 2009, 09:30:08 AM Hi Slim, i realise this post is years old but i wanted to know how you went fitting a rear seat to your van?
is it a major job or just a matter of getting a wagon seat, removing a part of the timber floor and bolting it in. thanks |