FE-FC Holden Discussion Forum

Hi all,

Had to move a heap of parts i had stashed under a friends house, for the first time in years i have got a reasonable idea of what parts i have.  If anyone needs anything specific PM me and have a look through the boxes of stuff as i sort them out....i hate selling stuff but i'm on a roll at the moment so get into it before i stack it all away and forget about it again...hahaha

Some of the bigger things i've found so far

Bonnet - FC special, dent and rust free, a really good one $150
13 x 7 Alloy 5 slots - CSA Brand, would polish up a treat, no gutter rash, fitted with servicable 215/50/13 TA's (may separate tyres) $500
14x8(2) and 14x7(2) Dragway Splats with new looking 235/60/14 and 225/60/14 tyres $600
bumperettes? painted yellow (hahaha) but dent free suit repaint or re-chrome $200 pair
Found heaps of starter motors and a few alternators (no generators yet...) for some reason - any offers?
original front windscreen - $50
Redline 4 barrel manifold suit red 6 - looks as new- $150
390 holley 4160 - was a reco when i purchased it years ago - used for 12 months or so, been sitting for maybe 5 years so could do with a gasket set atleast.... $250
Open spacer above to suit 4bbl $10
rusty but straight fc hub caps x 4 $80
chrome dress rims - various condition - will have to check sizes
FC radiator - look to be in good nick $50
202 bottom end - was line bored, bored and honed when rebuilt, acl duralite's and acl bearings, JP straight cuts, was a virgin block before rebuild (thinks it's +20 now, will have to look) no cam -done maybe 20 000 k's max, again - been sitting for a few years now wrapped up...$600
Toyota 5 speed box, was noisy at idle so removed and replaced with another i had at the time, suit re-bearing or put up with the noise  for $100
Used Red 6 oil cooler setup includes lines, sandwich plate and cooler, good looking setup $80
Sun visors x 4 offers
single stromberg on red six manifold, was on a ht ute i had years ago, ran well but been sitting...$30
Muncie to Chev bellhousing (suit the large style flywheel?) $100
Muncie case - i used for dummy fit ups - no internals or side cover $120
FC Chromed firewall carb linkage $80
HR disc Spindles/rotors/calipers $260
LH disc spindles (cant find calipers and rotors yet but may have them) $80

WILL ADD MORE AS I DIG THROUGH SECOND LOAD....

Happy to send pictures to serious buyers and post at buyers expense (i'm in Hobart), i've got a lot on at the moment so bare with me i don't get back to your messages straight away

Cheers

2Door350

Id be interested in the bonnet...where in Oz are you?

  Hi  Would you have 2 thumbprint dress rims, like EJ premier, in amongst you bits.?
                                 Roy

no, all dress rims are plain

Happy to send pictures to serious buyers and post at buyers expense (i'm in Hobart), i've got a lot on at the moment so bare with me i don't get back to your messages straight away

CSA 5 Slots SOLD

hi would you have a fc grill and blinkers ?

PM sent re: oil cooler.  :)

PM sent re starter motor.

I'm chasing a couple of rear interior grab handles (dark green). Maybe a long shot, but had to ask!

Franno - when I bought my FE it had two red grab handles even though the rest of the trim was Summit Blue. As the handles were in good nick I decided to have them spray-painted using a special vinyl paint and the appearance and finish is identical to the original look. That was about 3 years ago and there have been no problems. If you have a good pair that aren't green it may be worth considering.

Ken

Message sent.

5 speed SOLD(pending payment)
firewall linkage SOLD
oil cooler setup SOLD
radiator SOLD
Starters SOLD
CSA 5 slots SOLD