FE-FC Holden Discussion Forum

Technical Board => Restoration Help => Topic started by: jack_fc on February 01, 2011, 01:01:41 PM



Title: remove and refit FC paint seperators
Post by: jack_fc on February 01, 2011, 01:01:41 PM
Gday All

I need some advice on how to remove and refit the paint seperators (between taillights and bumper) on an FC sedan.
How are they attached?
Dont want to damage them while removing...

thanks
jack



Title: Re: remove and refit FC paint seperators
Post by: customFC on February 01, 2011, 02:13:30 PM
These chrome pieces have tabs that insert into slots, they then fold over the panel joint to hold them in place.
Take a look in the boot below the taillights and you will see the tabs folded over.
Be careful straightening then, as they sometimes break when folded too many times.
Regards
Alex


Title: Re: remove and refit FC paint seperators
Post by: jack_fc on February 01, 2011, 03:22:35 PM


Thanks, Alex  :)
My car is at the painters; he rang asking if I knew how to remove them - bit hard to investigate when the car is nowhere near me!
I'll ring him and pass on your much-appreciated advice.
Regards
jack


Title: Re: remove and refit FC paint seperators
Post by: mcl1959 on February 01, 2011, 07:24:17 PM
After straightening, gently tap from the rear. If you prise them from the front, they will possibly break off.

Ken


Title: Re: remove and refit FC paint seperators
Post by: jack_fc on February 01, 2011, 08:21:27 PM
Ken,
Thanks for that very good advice  :)
cheers, jack


Title: Re: remove and refit FC paint seperators
Post by: GMHwagoon on February 02, 2011, 05:09:50 PM


  when you do straighten the tabs lightly tap them half way out then tap them back in
  do this a couple of times and it will loosen them up better


Title: Re: remove and refit FC paint seperators
Post by: jack_fc on February 02, 2011, 06:13:41 PM

Thanks, Greg  :)

That's the very best thing about this forum - so much great practical advice, all for the asking!

cheers, jack