|
Title: door assembly info Post by: fcvan on February 28, 2003, 02:56:43 PM Hi all. I'm just about to assemble my two doors(front) after getting everyhing detailed, and new parts etc.
There is one question I have to ask as I am not sure what to do/use. Inside each door is a connecting rod, which in the manual is referred to as the "door lock remote control connecting rod". There is a "silencer"/sleeve which fits over this which is made out of a sock type material. My "socks" were fairly perished. My question is - what can I use to cover these rods,either out of similar material or different and where do I get it. Thanks again Miikael Title: Re: door assembly info Post by: graham_fuller on February 28, 2003, 09:40:55 PM My suggestion would be a soft plastic tubing form an electrical wholesalers or maybe clark rubber.
cheers, Graham Title: Re: door assembly info Post by: fcfromscratch on February 28, 2003, 10:44:59 PM Miikael,
I had my wife sew me some long strips of T-shirt material (stretch knit poly-cotton) into long "tubes" which I cut into lengths to fit the connecting rods. Just gotta make sure the diameter of the tube is enough to fit over the "bends" in the ends of the rods... Do you have the little spring metal clips that they slide through as they actuate? If not, I can probably salvage some for you off my spare doors. Brad Title: Re: door assembly info Post by: mcl1959 on March 01, 2003, 08:51:26 AM I have quite a lot of these in good nick, I think I even have some new stuff. send me a pm if interested in purchasing
Regards Ken Title: Re: door assembly info Post by: fcvan on March 03, 2003, 02:09:13 PM As always, thanks for the replys. Brad I do have the clips for the doors ,thanks anyway. I'll either take your tip or get some off Ken.
Thanks Miikael |