|
Title: hole in my ute front panel Post by: narredude on January 16, 2010, 12:27:37 PM Hey guys and gals when i got my fe ute i noticed the panel under the grille had a hole in it i didnt think much of it but i recently spotted one ebay with the same hole was this a factory hole? what was it used for? or was it a pure fluke to see the same hole...cheers ???
Title: Re: hole in my ute front panel Post by: FC427 on January 16, 2010, 01:16:27 PM If it's what I think ??? some use to drill holes in this panel to get air on the bottom of the radiator, I have seen holes from 1/2'' to 1 1/4'' drilled right across this panel and some times only a few.....I am proberely wrong in your case ??? ??? ??? a picture would help .......FC427......
Title: Re: hole in my ute front panel Post by: RET on January 16, 2010, 03:55:28 PM There was an article in a Modern Motor (or Practical Motorist, or Wheels - one of the contemporary motoring magazines), that showed how you could fit a crank-handle to your early Holden. I've seen an FE fitted with one of these. (It was more of an issue with the early 6V Holdens, particularly in cooler climates.)
Does the hole line up with the harmonic balancer? cheers RET Title: Re: hole in my ute front panel Post by: CraigA on January 16, 2010, 05:11:40 PM ^^^
Could have been to drift a new harmonic balancer onto the engine. When I bought my FC had a hole exactly as you describe. Title: Re: hole in my ute front panel Post by: CraigA on January 16, 2010, 05:15:58 PM You can see the hole just below the centre of the grille.
(http://i50.tinypic.com/voxzsm.jpg) Title: Re: hole in my ute front panel Post by: narredude on January 16, 2010, 05:40:02 PM yes it does ret i was thinking a crank myself but craiga's idea sounds pretty good and his pic is identicle to how mine looked thankyou guys
Title: Re: hole in my ute front panel Post by: Glenn 'Stinky' Stankevicius on January 16, 2010, 09:14:58 PM ^^^ Could have been to drift a new harmonic balancer onto the engine. I wish mine had it and it makes bloody good sense having had to replace the balancer >:( Two blokes with a good aim in shifts with a hammer, about an hour later and we were done ::) Title: Re: hole in my ute front panel Post by: FCRB26 on January 17, 2010, 02:16:27 PM Hole for wiring for driving lights?????
|