FE-FC Holden Discussion Forum

Technical Board => General Technical => Topic started by: Ken's 57 on September 15, 2008, 02:18:30 PM



Title: Door Rubbers
Post by: Ken's 57 on September 15, 2008, 02:18:30 PM
Both of my original front outer door rubbers are in reasonable condition except for the section that runs along the sill panel under the scuff plate. I ordered rubber to suit and pictured below is the new section. If facing forwards on the driver's side, have I got it the right way up or should the wider profile be at the top? The originals were really damaged and it wasn't obvious when removing them.

Cheers........Ken

(http://i278.photobucket.com/albums/kk106/kenk/IMG_0212.jpg)



Title: Re: Door Rubbers
Post by: Bob_FC_Ute on September 15, 2008, 02:27:20 PM
The orientation that you have shown in the photo is correct for fitment.
regards Bob


Title: Re: Door Rubbers
Post by: Ken's 57 on September 15, 2008, 09:41:48 PM
Thanks Bob.