|
Title: Door gaps Post by: fccool59 on February 18, 2007, 09:20:52 AM what is the usual gap between the front door in the area the stainless mould ends (FC) and the door meets up with the cowl panel and top of the gaurd?
my door seems to be a tight fit Also while i am at it what is the usual gap between the b pillar and the door? mine touches the b pillar with about 4mm gap at the front of the door. Title: Re: Door gaps Post by: mcl1959 on February 18, 2007, 10:14:37 AM The door is usually very close to the A pillar where the chrome stripe goes through, but wider in other areas. It can be as close as 2 or 3 mm there, but 4 or 5 mm in other places between the guard and the door and the windscreen pillar and the door. The gap down the B pillar should be consistent over 4 or 5 mm
Ken Title: Re: Door gaps Post by: fccool59 on February 18, 2007, 10:38:55 AM in that case, to get 4-5 mm at the b pillar i think i might need to hire a porta power and push the a pillar a few mm forward at the bottom of the windscreen and file a little more of the door edges and drill out the hinge holes a little more.
Title: Re: Door gaps Post by: FATBOY on February 18, 2007, 10:43:12 AM hey leon mi ute was the same before i put the nos a pillar on after putting it on i adjusted it with a jack diagonally to get better door gaps
cheers fatboy |