FE-FC Holden Discussion Forum
April 28, 2024, 03:45:45 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: Are you a member of one of the FE-FC Holden Car Clubs of Australia ? If you are, get access to the Club-Member-only area of this discussion board. Send an IM to the board admin, including your real name and club to get access.
 
   Home   Help Search Calendar Login Register  
FE-FC Holden Discussion Forum > Technical Board > General Technical (Moderators: RET, Glenn 'Stinky' Stankevicius, gp) > Rear main bearing seal for Grey motor
Pages: 1 [2]   Go Down
« previous next »
  Add bookmark  |  Print  
Author Topic: Rear main bearing seal for Grey motor  (Read 13704 times)
Fraze
Full Member
***
Offline Offline

Model: FC
Posts: 202


View Profile
« Reply #20 on: September 06, 2022, 07:12:36 AM »
0
Prior to fitting the rope seal , use a centre punch and put 5 or 6 punch marks in the bottom of the groove in the seal channel in the block and bearing cap. Secondly use a good oil resistant sealant on the rope seal before fitting. These are tips I picked up from  research on seal fitting from the experts, also check out utube. Cheers,Fraze
Logged
Pages: 1 [2]   Go Up
  Add bookmark  |  Print  
« previous next »

Share this topic...
In a forum (BBCode) 
In a site/blog (HTML)

 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Valid XHTML 1.0! Valid CSS!
Page created in 0.031 seconds with 20 queries.