FE-FC Holden Discussion Forum
October 17, 2019, 05:24:49 AM *
Welcome, Guest. Please login or register.
Did you miss your activation email?

Login with username, password and session length
News: Are you a member of one of the FE-FC Holden Car Clubs of Australia ? If you are, get access to the Club-Member-only area of this discussion board. Send an IM to the board admin, including your real name and club to get access.
 
   Home   Help Search Calendar Login Register  
Pages: [1]   Go Down
  Add bookmark  |  Print  
Author Topic: Exhaust flange stud  (Read 248 times)
HoldenFE
Newbie
*
Offline Offline

Model: FE
Posts: 23


View Profile
« on: May 10, 2019, 05:25:15 PM »
0

I have snapped the stud when tightening up the exhaust pipe to the manifold on the grey motor.
I have tried various exhaust shops in the Dandenong area, Rare Spare etc with no luck.
The stud has a coarse thread that screws into the base of the manifold and a fine thread where the exhaust flange and pipe bolts onto the stud.
Does anyone know where l can purchase one please?
Logged
REDMR2RED
vic-club
Senior Member
****
Offline Offline

Model: FC
Posts: 514


FC Ute's d'best


View Profile
« Reply #1 on: May 10, 2019, 05:49:19 PM »
0

PM Sent
Logged

1959 FC Holden Ute
zulu
nsw-club
Guru
*****
Offline Offline

Model: FE and FC
Posts: 1770


Old Boonah Ambo


View Profile
« Reply #2 on: May 10, 2019, 08:38:59 PM »
0

From memory I think later model holden  exhaust manifold studs fit although the end that goes into the manifold is a thread or 2 short of the of the depth required  but still ok.
Logged
Pages: [1]   Go Up
  Add bookmark  |  Print  

Share this topic...
In a forum (BBCode) 
In a site/blog (HTML)

 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Valid XHTML 1.0! Valid CSS!
Page created in 0.051 seconds with 20 queries.