FE-FC Holden Discussion Forum
April 29, 2024, 06:51:48 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: The FE-FC Holden Car Club of NSW are proud to host the 19th FE-FC Holden Nationals. Check out the announcement video for more.
 
   Home   Help Search Calendar Login Register  
FE-FC Holden Discussion Forum > Technical Board > Restoration Help (Moderators: RET, Glenn 'Stinky' Stankevicius, gp) > Heater Location
Pages: [1]   Go Down
« previous next »
  Add bookmark  |  Print  
Author Topic: Heater Location  (Read 1575 times)
TTV6FC
Guru
*****
Offline Offline

Model: FC
Posts: 1132



View Profile
« on: April 04, 2009, 04:01:41 PM »
0
When aftermarket (Smiths,Nasco,Tao etc) heaters were installed,was there ever a "particular" location that they were placed other than just"under the dash,somewhere".I have removed the old style fresh air blow through type heater from the black FC and welded up the holes as I have a slightly later electric heater to install.I have seen them in the middle and also off to the passenger side but am wondering if there was supposed to be a specific location.



Cheers,Jamie.
Logged
Run your fingers over my Holden and I'll run my Holden over your fingers!!!!
mcl1959
vic-club
Guru
*****
Offline Offline

Posts: 6155


FE's rule


View Profile
« Reply #1 on: April 04, 2009, 04:37:36 PM »
0
No the instructions are not specific describing exactly where to drill holes. The Nasco heater was specific and even gave a template with the instructions as to where to drill the holes.

Ken
Logged
Pages: [1]   Go Up
  Add bookmark  |  Print  
« previous next »

Share this topic...
In a forum (BBCode) 
In a site/blog (HTML)

 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Valid XHTML 1.0! Valid CSS!
Page created in 0.03 seconds with 19 queries.