Thanks, I'll pass it on.  

There is a club called Townsville Early Holden Club, and can be found at http://home.austarnet.com.au/jamieson/Townsville_Early_Holden_Club.html
I'm not sure when the last update on the site was but I think that there is a telephone number there.
I also beleive that there will be some sort of early holden club starting in Cairns in the next few months.
Hope this helps
Regards
Jason.

Does Martin do FJ mats also?
I have a friend who is trying to locate some for his old girl.
Regards
Jason.

Richard,
Is there room on the site for a photo section?
I don't know whether or not people would be interested, but thought it was a good idea at the time.
Regards
Jason.

Hey Ed,

Hopefully one of those sets has my name on it.
Shame about the heater.  
Let me know when you have them in hand if you could.
Regards
Jason.

Thanks for the info Richard, I will look into it, as well as finally joining the Queensland Club.
Regards
Jason.

I am up in Cairns, but want to get to the nationals probably next year or if not the year after. But plan to drive the van to Melbourne when completed to show the family.

Thanks again
Jason

  Thanks Richard for the scan of the brochures, they are exactly what I have been looking for and with the purchase of an Fe Ute the other day, I have the pair.
Thanks again
Jason.

Thanks for he pics Alex, I have sent a couple back of mine with the before and now shots.
Cheers
Jason

Thanks Ken,

Mine should be on the road in December / Janurary sometime so another one for your list.  
Jason

Apparently the P76 Rotors can still be bought new......and as I am putting commodore stud patern on the back, they have to be drilled to the same pattern on the front, but you can also get them as a blank rotor so I am told.
I have used the Hadfield front end with th Rack and Pinion steer, but my car is a fair way from being on the road so I can't tell you what it is like yet.
I am planning on using the Vt brakes though out of my donor vehicle.
Jason  

Thanks

I could not remember whether or not we spoke about it on the phone.

Do P76 Leyland rotors fit the HR stub?

Does anyone know the original rolling height of a standard 13inch rim and an original tyre.......Am trying to work out the biggest rim and trye combination for Queensland registration.

Cheers
Jason.

Any Photo's?

Hello Tony,

Great book.....Do you know if one came out for the FE, because that's the type of gear I am chasing.
Looks like a few FJ guys want that one with the bid over $120.....
Thanks
Jason

G'day Richard,

If you could scan the brochures that would be fantastic, the only brochure I have seen is that of the FC.
I had seen Ken's car before he sold it in Victoria and the photo of the one that you have is the other one that I have seen through the Nationals this year, but only by photo.
There was another one in a Vanning magazine the I found dated 1980's.
If interested the Id No is FE-2104-4345-A, so I am assuming about half way through the build of Vans.
How did you insert that image?

Jason

I am trying to locate any advertising material or photo's of Fe/Fc Panel Vans. If anyone has any photo's would it be possible for an email?
I have only seen two photo's of other Fe Vans still on the road and was wondering how many may be left.
Thanks
Jason  

This is the best one yet.......Hopefully smooth sailing from here.

Jason

Hey Ed,

I will be in for a couple of those for the Van. Leave a post when they are done.
Regards
Jason