Our Families Single tone FC Special Station Sedan taken early sixties

There are two size holes...just try with the clips
there is just over a mm difference
The photo may be misleading..all the holes without the snap sacs are the same... smaller than the snap sac holes

I also checked with a rear sedan door ..they have snap sacs along the bottom, all the hinge side inc the top one and one on the opening side
half way around the curve

8 snap sacs and 5 clip holes in total

My ute has 5 across the bottom and 2 on the door opening side only
ie. none across the top or hinge side

Cheers gary

Great to hear John...Time to find a new mechanic

Sorry Harv ....my bad....

John how hot does it get 
at cruising and at idle...I know that you dont get to a great speed so the engine should not get too hot ?

I have been across the paddock 3 times in my ute without a temp gauge
I have a modern 3core radiator core with original tanks and haven't put water in on either trip
One of the trips that I did without company I sat on 68 - 70 mph for the whole trip
The other I came back with Jim and again did not put water in

Cheers gary

G'day Harv

Black sender is EJ on  part No. 7418881

 The brown sender...No. 741533 ..The original part no for the late FJ eng no. 173093 FE FC EK  was 7407528 and was superseded by 7419533

So the early Fe had the same sender as the later one.? 

 I have NOS 7419533(Brown) and 7418881(Black) but dont have a box with 7407528 
 

Hey Frank ...I have a NOS Lucas, Bosch, Hella and tridon  Take your pick
Cheers Gary

Are these the original bolts for the centre bracket
If so it's no wonder they pull through

Hey Ken I will take the two gearbox kits
Cheers Gary

Good read ...great value !!!

EAGERS Brisbane display back in the day

Hey DJ
Smiths Holden was in Adelaide and Sydney Atkinsons was in Perth

Another milk bottle, this time from the West

Sydney Atkinsons

Spotto at the lights in Cannington
Came back later and parked around the corner
Retired panel beater with a V6 ...nice car inspired by Geoff Sheafers FC
 

Hey Tim

If you still need a workshop manual I have a spare you can have

Pm me your postage details

Cheers Gary

Hey Kevin

I have the end stainless fittings and the center bracket if you get a good visor without them

Cheers Gary

That's a bugger Bill
Hope it all works out in the end
Wishing you and Judi all the best and hopefully get back on the road for more happy
travels
Cheers Gary & Lorene

An unusual item to advertise a Holden dealer on...makes a great conversation starter.
There were quite a few dealers..not just Holden that used milk bottles back in the day.