I believe Holden switch the Earth (negative), so check where the wire a the bottom of steering is going to, should be Earthed. Power (positive) to the horn at all times, hope this helps.
Cheers
John

I turned up a steel slug 0.003" smaller the the seal journal on the crank & used this to fit the rope seal.
Cheers
John

Hi Helen,

Yes I do have some stock, I will send you a PM.
Cheers
John

I may have a set, is the bolts for the front hanger on the rear springs?
Cheers
John

Sorry mate I can not help.
Cheers
John

Has any one had to buy new centre bolts if so where did you buy them...my local bolt supplier has centre bolts but not the size I need...

I may have a set, is the bolts for the front hanger on the rear springs?
Cheers
John

John ..If FCEE doesn't take it ,I will ,let me know if it becomes available ..thanks Vern .

Hi Vern,

Looks like it is yours, do you want me to pack & post it, pick up as I am at Penrith.

Cheers
John

I have a steering wheel only no horn ring, BUT it will need to be restored.
$50.00 plus postage.
Cheers
John

Bugger.

I didn’t even know that was on, that 10 minutes from my place.

How do we get to see what events are coming up?
Ric.

I think you need to be a member of the FE FC Holden Car Club of NSW to get messages about runs etc.
Cheers
John

Hi Kevin, is the king pin & bushes set for the FC, if so can you please advise postage to 2745.
Thank you,
John

Maybe you can make a heavy wall spacer tube with the length of the contact length of the conrod pieces & torque the bolts & nuts up in a vyce. Cheers John

I am sure you will find a sealed bearing for the attached link below.


http://www.nsk.com/common/data/ctrgPdf/e396a.pdf

Cheers
John

Hi Mark, all good thank you, I managed to get some.

Cheers
John

PM sent Ken.

I am after 2 FC Metal Fuse Holders, NOS or good second hand.

As I had a blown fuse & when dismantling the plastic insulator on the end broke up in to pieces.

Thanks for any help.

Cheers
John

When I have carried out an oil change & opened up the filter canister it is always full, the oil has not syphoned away.
Cheers
John

Be careful using Stainless Steel Sleeves & Pistons as simular metals will pick up on each other.

Battery trays are like wiper switch knobs, gear knobs and front subframes, unfortunately.
How badly rusted is yours, and how are your welding skills?

Rob

I have Gear Knobs available.
Cheers
John

Pete Mallaby makes a great set of the spacers.

Sorry try fcwrangler.

You could try Wrangler, he is on this forum.

Cheers
John