She looks pretty crunchy 

 We get a couple a day on the FB/EK forum RET, how many do you have to contend with ? I remember at one stage we were up around 30 a day 

 Anyone have one or a picture of one ? Interested to see the colour on a car

 G'day Mal, guessing you are retired now , this thing has probably got plates on it the way you work - how about an update mate ??

 Thats going to be one blinged up ute  I spy a set of Tasman centre caps ......... 

 Looks  a treat Mal, did you do the porting and polishing yourself ? Be careful when you put the lifters in mate   

any updates Mal ?

 Unfortunately I don't have any good ones here Rob, its a shame you didn't need them a couple of months ago , i am certain there was a pair on the EK that sat upside down in the bush for many years, the bulk of all the normally rusty stuff on that ended up in Canberra for Brett's ute project, but being a ute those bits wouldn't have been required and are now on their way to china ....... 

Rob,  are the jacking points left and right handed or symmetrical ? I have the next couple of days off so i will have a dig around in EKmart for a suitable replacement

 Was working up around Coober Pedy the other day and found a couple of FE/C's - heres some pics of the tags for Ken and whoever else is interested ...

 

 

 This car had very little rust in it , shame it was so knocked around 

 

 

 Sweet 

 Couldn't he get one in Esperance

 Looks good - the car certainly had potential , and you have done a great job of cleaning it up.

 When did you buy it Gwen ? Just recently or a while ago ?  The car had potential , but it was a LONG way away from what he told me over the phone - there was rust in the inner sill that would have had to be repaired , seat belts missing , lights not working , the rear bumper was only attached by one bolt on each side , etc etc etc .  It was a good looking car but had been poorly reassembled after paint.

 No I didnt , it was supposed to be ready for rego - when I got to Canberra on the thursday before easter and went to pick up the car , it had oil leaks, none of the lights worked , it was running like a dog , seat belts missing , etc so I gave it a miss.

 No worries Leon, our loss is your gain 

 We have a room booked that we wont be using  Its a family room (2 adults,2 animals)at the Quality Inn.
 

 John, what the hell are you thinking ? ? ? ? ? ?   

 Ed, if that grinder just stopped with no warning, it more than likely just needs brushes.
 If you unscrew the two black brushholders from the main body of the grinder and remove them , check if one of them has a small pin sticking out the end that contacts the commutator. Bosch grinders have a built in cutout inside the brush so you dont wear the brushes down to nothing and destroy the armature.
 A set of brushes should be less than $10 - while you are at it, pull the end off the gearbox and replace the grease and your grinder will be as good as new.
 HTH

 Remember this one ?
 http://cgi.ebay.com.au/Holden-FC-Ute-Left-Hand-Drive-and-Trailer_W0QQitemZ250156466884QQihZ015QQcategoryZ101895QQssPageNameZWDVWQQrdZ1QQcmdZViewItem