 Show Posts
|
|
Pages: [1] 2 3 ... 5
|
|
5
|
For Sale and Wanted / Cars For Sale / fe ute
|
on: May 07, 2007, 09:30:16 AM
|
fe ute for sale . 149 red motor 3 spd all synchro box floor change eh diff and brakes all round7 inch rims with good tyres ek wiper motor 2 speed warmaride heater demister new rubber kit thruout retractable seatbelts bench seat sunroof new black hoodlining and windlacing new extractors and strait cut timing gears just been resprayed yellow comes with some spares unreg in eden nsw on the cost near vic border ready for rego 5000$ ono contact danny on 0264964164 forced sale i cant get in it any more cheers  |
|
|
|
|
7
|
General / General Board / club runs
|
on: April 08, 2007, 07:33:22 AM
|
when are you people going on a run down south ?i would like to catch up with some of you cheers danny |
|
|
|
|
11
|
For Sale and Wanted / Parts For Sale / crank and pistons
|
on: September 16, 2006, 07:33:32 AM
|
|
149 standard crank plus 30 thou pistons with new rings plus sump to suit red motor into fe for red motor $60 the lot plus freight i will seperate cheers danny
|
|
|
|
|
16
|
For Sale and Wanted / Cars For Sale / Fe Ute
|
on: May 24, 2006, 02:24:44 AM
|
|
fe ute with fc grill and blinkers sunroof center roof aerial
ek heater demister 149 red motor 3 speed all syncro floor shift and box new rubber kit through out new black cloth hood lining and wind lacing bucket seats retractable seatbelts cd player oil, temp and vaccum gauges taco new carpet black cloth door trims and kick panels newly painted canary yellow no rust on club rego
new extractors plus spares. $5000 ono or swap for small/medium car to same value.
contact danny (02) 64964164
Eden far south coast NSW
|
|
|
|
|
17
|
Technical Board / Modification Help / extracrors
|
on: March 06, 2006, 09:38:54 AM
|
|
could someone tell me if extactors frm hktg fit fe with a red motor iknow they fit engine its the part past the starter to under body im not sure about thanks danny
|
|
|
|
|
19
|
Technical Board / Modification Help / cross member
|
on: December 22, 2005, 09:38:41 AM
|
could someone please tell me if a eh front cross-member will bolt into a fe-fe? and do the engine mounts have to be moved? cheers danny |
|
|
|
|
