More than likley the later wider spring was used to replace a failed narrow FE spring

Rod
There should be a seperate plate underneath the lower wishbone to locate and bolt the shocks to

http://forum.fefcholden.club/index.php?action=post;quote=139968;topic=22894.0;num_replies=8;sesc=3862198f3f333bf4696a6780f64bd86c

The 3801 Grey Nurse has pulled up unscathed in Coledale NSW after its journey from Hoppers Crossing!

Ken
Looks a cross between Bluebird & a Locomotive
I'll start the bidding at $50 + postage!
Gary

Rob,

recently had the same blank look / response re the ferruls, good luck trying to find any in the metro area, or even anyone who knows what they are or what you're talking about, even with an old sample!

Looks like found object is receiving deserved treatment, keep up the good work

Is this what you're looking for? $38

THEGURU

PM sent

I had 2 until a few years ago then I gave one to a mate with a EK . I still have one but don't wish to part with it as it was standard issue with the dickie seat conversion because the passenger would find it nearly impossible to get in or out without it . But if you are serious I know someone who could make one in stainless as the chrome would be original and a little tired . Cheers . Haydn

Orthodontist's bar I call em, someone on the forum was going to repro them, do a search

There are at least 2 types of 2 piece visors, the most common with an aluminium edge and a poverty job with no aluminium edge

Wookie

No panic straps in wagons

PM sent

Kevin (old blu) on here has a grey motor ute running air con, not sure but I think the compressor is on the battery side

It would be great if someone could make up a bolt on kit for grey motor air con

Kev, show us your air con

Stinky,
Not sure how much difference it makes, probably not a lot, but the Station Sedan rear door is square at the back top corner unlike the sedan which is rounded

Steven,
Pictures attached, when you measure/ cut allow an extra couple of inches where it goes under each end of the scuff plates

Gary

Hey Doug, nice car, Maco on here sells reproduced FE FC gearstick knobs, they are the same on both models, although I'd stay with the FJ knob as it fancier and adds a point of difference
FE did not have tailfins, although there were an accessory aftermarket set produced which you don't see too often



Cheers Gary

Attached image of some of the kits that may have been available



Old Blu, I think Dan may have given me the Victoria single line kit on our FC Standard Wagon

Need to drill a lot of holes to fit one of the kits though

 

FE Special Sedan & Station Sedan had gutter trim, I don't recognise the body trim package, will have a look in the files.

I think EK front springs are slightly thicker, you could try Kings Springs, I think rare spares sell them?