 Show Posts
|
|
Pages: [1] 2 3 ... 16
|
|
4
|
Galleries / Project Cars - FEs and FCs Under Construction / Re: Found Object
|
on: February 25, 2022, 09:26:11 PM
|
|
Here’s another option, drill a couple of 1/2” holes under the scuff plates, block off sill drain holes fill sills with used engine oil. Unblock drain holes and drain oil into containers (not on lawn or driveway!) then park in garage with flattened cartons underneath drain holes for next week. Voila! Sorta like where the engine or gearbox leaks cover the underneath of your car, no rust there!
Sent from my iPhone using Tapatalk
|
|
|
|
|
6
|
Technical Board / General Technical / Re: Hy-way external sunvisor
|
on: October 31, 2021, 09:35:59 PM
|
|
Hey Lazlo your local sheet metal shop will be able to fold some brackets out of stainless using one of your originals. The brackets will be plenty strong enough to keep your visor in place because the visor is held captive in the gutter by the brackets and the chrome band should stop it bending in the middle.
Sent from my iPhone using Tapatalk
|
|
|
|
|
8
|
For Sale and Wanted / Parts For Sale / Free stuff
|
on: October 24, 2021, 08:42:17 PM
|
|
I’ve got a couple of engine blocks which are FREE plus whatever grey motor bits and pieces I have left over . Please come and get them I’d like to use the space!
Located Batemans Bay
Sent from my iPhone using Tapatalk
|
|
|
|
|
9
|
For Sale and Wanted / Parts Wanted / Re: FE exhaust manifold
|
on: January 25, 2021, 09:37:12 PM
|
|
Gidday John, I’m sorry I’ve passed the manifolds on to Rob (ardiesse) on the Fb/Ek forum. My bad, maybe if you check with him he might be able to help you. I think Alzheimer’s has got me! Mark
Sent from my iPhone using Tapatalk
|
|
|
|
|
14
|
For Sale and Wanted / Parts For Sale / Garage cleanout 3
|
on: November 07, 2020, 04:35:22 PM
|
Gennie and bracket $20 most likely works! SOLD  Fuel pump $20 SOLD  Fuel/vacuum hoses $10  Fan and coil $10  Tailshaft yolk for gearbox end $10  Air cleaner,breather cap and rocker cover $50 Breather cap SOLD  Sent from my iPhone using Tapatalk |
|
|
|
|
15
|
For Sale and Wanted / Parts For Sale / Garage cleanout 2
|
on: November 07, 2020, 04:27:44 PM
|
Manifold 1 $20  Manifolds 2 and 3 $20ea  Distributor with cap $25 SOLD  Distributor no cap $15 SOLD  Thermostat housing top and bottom with old thermostat!$10  Thermostat bottom housing with bonus heater tap ( needs freeing up)$10  Sent from my iPhone using Tapatalk |
|
|
|
|
16
|
For Sale and Wanted / Parts For Sale / Garage cleanout 1
|
on: November 07, 2020, 04:21:06 PM
|
|
Grey motor block #B268257, 40 thou over, tiny pinhole rust thru in one cylinder. Comes with crankshaft and main bearings/caps. Date code is A232 which might be Jan 23 1962?
$50
Grey motor block #286605, standard bore, comes with mains and caps date coded C222 which might be Mar 22 1962?
$50
Also have available set of tinware (side plate cover,timing gear cover,sump,rocker cover plus oil pickups (2 of),harmonic balancer and fan pulley $100.
Sent from my iPhone using Tapatalk
|
|
|
|
|
19
|
Technical Board / Restoration Help / Re: FE/FC Rear Screen Rubbers
|
on: December 22, 2019, 03:07:29 PM
|
|
When I used a generic rubber length for my boot seal it took some adjusting of the boot lid to get it seal properly. I locked myself in the boot to check it, that was fun!
Don’t forget to put the seal up the right way, which I think is the pointy part of the profile facing towards outer lip of the channel. Sorry if you already know this but it had to be said. Good luck Vern.
Sent from my iPhone using Tapatalk
|
|
|
|
|
