Messages

G'day Vern I have both springs 7416274 and cable 7409623 NOS

$130 plus postage if you cant get anything closer

Jolls ...this is the jack you should look for its out of my FE Ute
Cheers Gary

Left and right not interchangeable they look the same but have a different angle once installed. If you try and swap them the arm will hit the hoodlining

           3 A6 is the lower inner spacer and 3A5 is the upper control arm spacer

           this is the closest I can measure as the battery on my caliper has died
           
Hope this helps....Cheers Gary

Safe travels guys…looking forward to your diary

Ken those parts are listed in the Fc parts catalogue dated 87-H-58

G'day Glenn...sent you an email

Cheers Gary

I have a NOS one here. I will take a pic tomorrow in the daylight
Does it have to be high res as can do with a SLR image if needed
Cheers Gary

PM Sent

Heres a pic of an FE Ute external mirror...It has the part number 7384468 on the back as well as the NASCO Logo
The parts book shows for ute and van as well as showing the van did not have an interior mirror

going through some of my stuff and came across these wind deflector parts

The green one is a top for an FE-FC Sedan part No 7406498

The 4 parts with a reddish ting are for an FE FC Ute after market must have bought them a while ago as the wrapping paper is 2002

The clear bottom bits suit FE FC 3 right and one left
The other Clear tops I am not sure as the length varies
and one set to suit FB-EK I think

I have a contact that can do plastic moulding will give him a call and see if he is interested or has time

Sorry Rich...searched all my boxes and came up short...I think they may have gone walkabout at the last swapmeet I went to.

Rich I think I have some bits of the seat trim from an FE ...will let you know ...I can send over a small broken piece as it was from a low mile FE Standard 

G’day Ken I will take that if still available
Cheers Gary

Peter the screws are interchangeable ..I took them out and swapped them all ok and they look the same
This is the fitting instructions for a Ute but the holes will be in the same place as a sedan

In production now just waiting on the company ….it may close down due to virus...

Showing the ends of the wire attached to the shelf


Showing the back of the seat where the canvas is clipped to the frame

Showing the clip in the centre


Showing where the apron joins the seat

The wire is sewn into a pouch around the edge. It is a spring steel wire and has almost a loop at each end that is held in with a screw near the front of the shelf. There is a tab in the middle that it is clipped behind. The apron needs to be long enough so the seat can be adjusted fully forward. The apron is sewn in approx. 30mm from the top of the seat and has a canvas tail that is pig clipped to the frame. Hope this helps