Messages

Sorry Guys, I'm in St Albans, Melbourne, Victoria

Does anyone want a paid job for replacing the HR outrigger on an HR front end, with an EK outrigger. The front end is already installed on an EK and a red motor is also fitted (by the previous owner). I would attempt dropping the front end myself but I do not have a hoist to hold the motor up and my mig skills are not good enough. The EK outrigger is painted and ready to go

Cheers
Paul

Thanks for the info guys

A c/o HR crossmember modified with an EK outrigger will cost $250.00 from CRS. Rare Spares can also supply for $260.00

As I would rather not go through the pain (& cost) of replacing the crossmember, is there a "bolt-on" legal solution, which will allow fixing the HR outrigger, to the EK subframe?

Remember that  the HR outrigger currently sits 60 mm away from the subframe which it should be bolted to?

Cheers
Paul

Hi Guys,

This EK with an HR front and rear end, 202 and 3 speed crunch box off the original 138 is my 1st project

Rare spares tell me that they cannot help with the outrigger mounting. Is such a mod available and is it something that will just bolt on or is welding required?

Also, any ideas where I can get a rear handbrake cable guide/mounting. I assume this will be a duplicate of what is used on an HR.

As these questions have probably been asked before, how can I easily find information on a previously discussed topic, within this forum?

Any advise/help would be greatly appreciated

Below I attempted to attached a pic of how the outrigger is currently fixed, but it does not seem to have worked

"F:\Data\Photography\EK\arm.jpg"

Thanks
Paul