News:

Are you a member of one of the FE-FC Holden Car Clubs of Australia ? If you are, get access to the Club-Member-only area of this discussion board. Send an IM to the board admin, including your real name and club to get access.

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - FBvisitor

#1
Hi there,

I recently sold my EK wagon which was fitted with sealed beams. They worked a treat and were heaps better than my FB's standard set up. There were no modifications to run these lamps.

Cheers, Jason.
#2
Parts For Sale / Re: HONEST KIWIS PART SALE NOW ON
January 22, 2004, 06:17:45 AM
Steady on fellas, I'm $180.00 down and have been waiting over a month and a half and still no parts.

fbvisitor - trying to bite his tongue and be patient

#3
Parts Wanted / Re: fc frt gaurd rust repair panels
January 04, 2004, 03:39:38 PM
G'day Kiwi,

Try here,

 http://cgi.ebay.com.au/ws/eBayISAPI.dll?ViewItem&category=32058&item=2452215522

By the way, I'm still waiting for those Fender Spears. I'm guessing you didn't send them by air mail.

Cheers and beers, Jason.
#4
Parts For Sale / Re: fb ek gaurd spears nos
November 22, 2003, 12:59:14 PM
G'day Kiwi,

I've sent you a PM.

Cheers, Jason.
#5
General Technical / External Sunvisor underside colour?
October 09, 2003, 10:38:21 AM
Hi all,

A question for all those lucky people with Nasco external sunvisors fitted to their cars. What is the usual colour of the underside. I have been told a flat green colour was commonly used but I'm wondering if other colours have been used, flat black etc. My car is a pastel yellow.

Cheers, Jason.
#6
Restoration Help / Re: Standard sized tyres
September 24, 2003, 03:51:07 AM
G'day Brendan,

I have fitted "Hankook Milage Plus" tyres to my FB. They aren't quite the original size (175/80 13) but do look very nice. They have about a 1/2" white stripe around them and cost me $64.00 a tyre about 4 years ago. They are quite reasonable to drive on and I was able to get them from a number of different tyre outlets here in Tassie.

I hope this is of help to you, Jason.
#7
General Technical / Re: Benchseat Floorshift
May 05, 2003, 11:25:59 AM
G,day Matt,

Regarding the seat, I have seen a notch about six inches wide and a couple of inches deep made in the front which looks spot on. Perhaps a trip to the seat trimmers is in order?

Cheers, Jason.
#8
General Technical / Re: Door lock problems
May 05, 2003, 11:21:10 AM
Thanks Leigh,

I pulled the door trims off the other week and went berko with the crc. Problem now fixed.

Cheers.
#9
Restoration Help / Re: Reconditioning a Battery??
May 01, 2003, 12:18:15 AM
G'day Ken,

Down in Tassie your battery can be refurbished for about $120.00

Cheers, Jason.
#10
General Technical / Door lock problems
April 17, 2003, 09:51:40 AM
G'day all,

The drivers side door lock on my EK will not unlock if I lock the door by holding in the door handle. Its usually OK if I lock and unlock it with the key and if that doesn't work I'd just go around the other side.

Well today that happened and the passenger side door did the same bloody thing as well. I'm sure this would be a problem that someone here may have had as I assume its just a bit of general wear and tear in the locking mechanisms of these fine old beasts.

Anyone got any ideas???

Cheers, Jason.
#11
General Board / Re: Red Radio Aerial Tips
January 31, 2003, 04:33:20 AM
Hi all,

I have a 1960 fb fitted with a red tip since new but will take whatever colour you are prepared to make Graham as I have just purchased an EK wagon with the tip broken off.

Cheers, Jason
#12
Parts Wanted / Re: spats
January 28, 2003, 06:41:36 AM
The spats on ebay have been withdrawn from auction (grumble grumble bugger) :-/

Cheers, Jason.
#13
Other Stuff Wanted / Re: Nasco master parts catalogue
January 27, 2003, 12:02:25 AM
G'day Slim,

The catalogue that RET is talking about is currently on EBAY. I came across it this morning.

Cheers, Jason.
#14
Keep posting Alex. I love em'

Cheers, Jason.
#15
G'day Twitch,

If you are up around the North Wet coast I'd give Cesco a ring in Devonport. I know they used to do Greys' and they are HSVs' engine rebuilders for their not so reliable LS1 engine up here.

Jason
#16
Parts For Sale / Warmaride Heater
May 02, 2002, 09:40:33 AM
Hi everyone,

I have a Nasco Warmaride heater, part # 7406627 that I would like to swap for an FB/EK Taxi Bar which I've been unable to find here in Tassie. The heater core does not leak and the fan works fine although it does need a coat of paint.

I know this is a FE/FC forum but I'm hoping someone may have come across one in their travels.

Please feel free to email me with any questions on the heater or info regarding the whereabouts of a Taxi Bar.

If you are not in posession of a bar but know of one and would like a heater we could come to some arrangement I'm sure.

My email address; jasonrc@southcom.com.au

Thanks.

#17
General Board / Re: Front Mud Flaps
April 09, 2002, 09:39:16 PM
G'day ChrisB,

Martin is definitely the man to see. His repros are spot on an d if you are lucky he may even split a set for you.

Cheers.
#18
General Board / Re: Nasco Accessories
March 24, 2002, 06:17:10 AM
Airchief,

I'd have to say a Taxi Bar. A big shiny piece of chrome which I have not got yet. :(

The search continues.

JC
#19
General Board / Re: Heater Ducts
January 16, 2002, 12:33:48 PM
Try Martin from Obsolete Rubber Mats. He may be able to help

0412 941 799          ah.03 9317 8725

Cheers, Jason