Messages

Rod,
The TAFE course looks good as a starting point. As a welder I can tell you that rust removal in a car is one job I really don't care much for. Learning techniques & how to use the appropriate tools will help you prepare things correctly & have a far greater chance of getting it right the first time. You may not learn to weld well but you will know some basics to help with your approach. I know very little about painting but preparing a car under guidance years ago helped me learn about & appreciate the trade. There's a ton of knowledge on here & some very cleaver people keen to see you succeed. Enjoy.

Thanks Dave.

I'm keen to have a go at most jobs but fully anticipate some are best left to the professionals.  Painting will probably be one of those but who know until I have a go.  Worst case is I have to sand back my effort.

Rod

Welcome aboard Rocket,

Google is always good for viewing how things should, and shouldn't be done.

But I've found this forum to be the best source of knowledge, inspiration and assistance you could ever ask for.

Cheers
Marc

Hey Marc

Agree with the your comments about the forum.  I've learned a bit already will going through a number of posts.

Rod

Hi Rod
     I went to tafe here in Newcastle  to learn to weld but I enrolled in a general welding coarse but should have enrolled in a body building coarse however the teachers took pitty on me and my age a realised that I was doing up a car and showed me how to weld thin metal and set tasks especially for me. ( still can't weld very well )

Thanks Billy, Just checked out a "Vehicle Restoration & Body Fabrication" course at Kangan TAFE in Melbourne.  Seems like a good place to start.

Hi All

I'm a newbie to this forum and looking for some direction.  I'm recently retired and looking for a project / hobby and decided on getting a FC.

While I'm searching for a car I 'm starting to set my garage up.  What tools are considered essential apart from the usual spanners & screw drivers.?

I haven't played around with cars for over 40 years but I'm familiar with basic mechanics and electricals. Bodywork, not so much.  Any suggestions where can I go to learn how to cut out rust, weld & paint.

Any other tips to get started would be appreciated.

Rod

Hi Tony,

How did the search go?

I'm about to undertake a similar search for a FC our family once had.

Any search tips you can pass on?

Rod