Messages

Cleaned up some old 20mm steel conduit, broke out the conduit bender and welder reasonable result. Thanks to all.

Found the bag on Facebook Marketplace


Sent from my iPhone using Tapatalk

Cleaned up some old 20mm steel conduit, broke out the conduit bender and welder reasonable result. Thanks to all.

Thanks Ken that’s it think I remember now.


Sent from my iPhone using Tapatalk

Hi all would anybody have a picture of the bracket used to hang a canvas water bag. Thank you.


Sent from my iPhone using Tapatalk

Thanks all for your help. Received jets from Classic pickup Supplies and they seem to do the job. Being in Victoria just haven’t been able to get out and try them. Maybe someday!!!!


Sent from my iPhone using Tapatalk

Thanks again for pointing me in the right direction. I searched the forum but could find anything but I was searching jets not nozzles. A simple thing.


Sent from my iPhone using Tapatalk

Thank you DJ I will give your supplier in QLD a go. Fingers crossed. If no good I’ll sell a couple of my first born (border collies) and buy from earlybitz. Thank you again for all your help.


Sent from my iPhone using Tapatalk

I’ve seen the earlybitz ones just have to save up for them. Thanks Errol


Sent from my iPhone using Tapatalk

Thanks for that I will give it a go.


Sent from my iPhone using Tapatalk

Hi I’m after just one windscreen washer jet. Chrome, threaded. Thanks all.


Sent from my iPhone using Tapatalk

Great information saved me thanks all 

For these trims


Sent from my iPhone using Tapatalk

Thank you does the trick.


Sent from my iPhone using Tapatalk

Thank you so much none of my searches came up with this detail. Thank you again.


Sent from my iPhone using Tapatalk

Hi all I am after a hub cap removal tool for when you have wheel trims fitted. I have searched and find a few old posts. Just a picture would be helpful. Thanks all.


Sent from my iPhone using Tapatalk

Hey Vern my inners from Better are the one shown in my 2nd picture. (Profile I call a Loaf of Bread!!) Sounds different to yours. From asking around sounds as if it is normal for the outer to protrude at first and they need to settle with the help of Rubber Magic etc. I will see how I go worst case is start again with Rares!!! Thank you for you thoughts.


Sent from my iPhone using Tapatalk

Thanks Ken excellent point about glueing to sill. The Better Rubber is a little different to the Rares. The rubber has formed corners at the B pillar and they are trimmed over the hinge area. When I dry fit the rear door they spill out at the B pillar. Wondering if need extra trimming or realigning the door will fix. The front rubbers have a triangle section around the top of the A pillar that look like it needs cutting off. I will ring them tomorrow to check. I spoke to them about the rear rubber and they reason that I shouldn’t need to trim. Was hoping for some rear life experience with Better. But if the the Rare is the way to go maybe I will admit defeat!!!


Sent from my iPhone using Tapatalk

That’s fine Vern I misread thought there were Better. Yours are most likely the same as Rares. Thanks for the reply.


Sent from my iPhone using Tapatalk

Bloody auto correct. Find= fit duties=fitted.


Sent from my iPhone using Tapatalk

Hi Vern are your Better inners the same profile as mine? (Second pic) I found the rubber seems to find better in the channel laying on its side for the rear doors and on its end for the front. Weird?  I dried fitted the rear outer and it jammed at the B pillar though look as if it has duties correctly. Was wondering others experiences with the Better before I took the next leap of faith! I might go the same way as you and use Rare outer. Good luck with yours love to know how you go.


Sent from my iPhone using Tapatalk