News:

Are you a member of one of the FE-FC Holden Car Clubs of Australia ? If you are, get access to the Club-Member-only area of this discussion board. Send an IM to the board admin, including your real name and club to get access.

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Stankman

#1
Sorry about the wait finally have some photos after working out how to upload them


Trans and shifter before the spacer


Shifter spacer that I made


Dash back together!


Full set of Jelly bean mags repaired and polished for the Pano!


Trans and shifter in along with the drivers seat on its rails


Wagon rear seat mocked up


Drivers and passenger seats in


Floor and Tubs, repaired, and painted
#2
Update on the Pano, I am Glenn (Stinky's) son Jonas and I am currently working on my Fathers Panel van in hopes of using it as well as the FE Sedan (SIK056) on my P plates.  ;D

Since moving house we have done quite a bit to the car in order to get it road ready. We have currently fitted an Aussie 4 speed with an Impala twin shift instead of the Speco which is making its way into the Sedan. We had to make a spacer for the shifter to work, and have bolted a Torana cross member to the trans and plan to weld in outriggers to the frame rails and floor in order to secure the cross member and trans. Whilst doing this i have welded most of the trans tunnel and am waiting on Dad's assistance to complete it. We have also cut out the Panel van floor section and fitted a wagon rear seat with a pair of Capri buckets on BA Falcon rails in the front. This will allow passengers to get into the rear, these seats will be trimmed in a red and black leather combo by Dad. We have also gotten a set of 14x6 (F) and 14x8 (R) Jelly bean mags that we are yet to get tyres for, but are hoping to fit 245's on the rear! ;D Once the car is complete we plan to get it switched over to dedicated LPG so it will be cheaper to run daily, and hope to get the plates SIK059 for the Pano to match the Sedan (SIK056). I am very keen to get the Panel van on the road and drive it daily but unfortunately Dad shows the same amount of enthusiasm and will most likely rip the keys out of my hands for the first drive!   :-[

Photos to follow this, hopefully tomorrow night when I get the chance
#3
General Board / Numbers for Ken
February 14, 2016, 01:47:56 PM
Hi there, these numbers are off my FC Panelvan

NO:           FC-2104-6257-A
TRIM:           199-653
PAINT:   256-2033
   -
RPO:   333     TOP

Chassis Number: FC-42198-S