Messages

Thanks for the reply guys, 132 engine from an FE. I'm in Melbourne.

Need a Bosch distributor for my old grey - rebuilding mine, so not too fussy about condition. Thanks.

Thanks, Clay. Spot on!

Trying to chase down some 1&1/16" and 1&3/16" rubber seals to rebuild slave cylinders on my FE. Bit hard to find online. Any ideas who might sell them? Thanks

Thanks folks...a wealth of knowledge.

Can someone tell me whether the external two piece sun-visors were an option on the FE/FC or an after-market piece? Thanks

Thanks, Rob. Haven't looked at Nasons, but the JPs are really expensive being almost custom made and, so, are a last resort.

Chasing up a set of 3"+.062 pistons for grey motor rebuild. Most suppliers seem to carry +.125. Appreciate any suggestions.

Chasing up a single rocker mounting stand from early model 132 grey motor (one small, one large bolt). Original rear one cracked. Located in Melb. 0434 679 996 - Mario

Hi folks,

Chasing up a horn ring for an FE (full circle, not FC bottom half). Happy to pay or trade.

Thanks

Mario