News:

Are you a member of one of the FE-FC Holden Car Clubs of Australia ? If you are, get access to the Club-Member-only area of this discussion board. Send an IM to the board admin, including your real name and club to get access.

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - FE_280E

Pages1
#1
General Technical / Re: Where do these bits go
August 26, 2014, 01:16:05 AM
I'm with Sheriff. Yeah, bolt in the spare wheel well for the exhaust hanger with the stock tail pipe, but there is only one there. Been soo long since I broke down mine...
#2
Modification Help / Re: Mini tubs vs rear rail modification??
August 25, 2014, 09:15:38 PM
Yeah have been reading the NCOP, trunk has to be sealed from the cabin.Fitting a steel fire wall behind the seat to replace the old fiber board cover that normally lives there. The merc tank also has a internal venting system to dump fumes to under the car through a valve thingy.
#3
Modification Help / Re: Mini tubs vs rear rail modification??
August 25, 2014, 08:38:19 PM
Hi Guys
I've fitted a 75 litre tank out of a 1977 W123 into my FE sedan. Mounts on top of the diff hump behind the rear seat as it did in the merc. Spare wheel wont fit now in the original spot,so might end up fitting the merc boot floor with the spare wheel recess in it....
#4
Modification Help / Friendly ACT Engineer ?
July 13, 2014, 11:44:56 PM
Hi
Just wondering if any of the Canberra/QBN guys can recommend a "friendly" engineer ? Have been told AKZ Vehicle Engineering is pretty good, but curious as to who other guys are using in the area.
Cheers
Merc
Pages1