Messages

I am asking $8k for engine. regards jim

forgot to supply my ph. 0265592132. regards jim

due to ill health motor is for sale. have all receipts on build. can be viewed in General Technical page 4 under my blown grey. Offers considered

the balancer is stock standard balancer & rubbers of an FC grafted onto a aftermarket pulley designed to accept a blower drive pulley. cam specs. are inlet opens 28.86 BTDC & exhaust closes 30.72 ATDC. It has a cam overlap of 59.58 degrees. This is the recommended cam for my boost by SURECAMS who ground the camshaft.The pulleys are 6K polyrib the ratio 1-18 :1 which is 18%overdrive. There is a backfire valve below curved inlet tube with an area of 5.3 square inches. Apart from the blower drive system & the cam grind this is the same setup used in the early sixties with sucess. regards jim

  Hi Guys
  Here are some pics of the bearing cap straps being made

hi guys here are some pixs of bearing caps

number 2&3 main bearing caps have strenghtheners

Hi guys
Have enclosed some pics of my grey motor after assembly.  Rebored to 3 1/8”, new pistons, rings, camshaft grind, new bearings, heavy duty main bearing caps, line hone block.  Camshaft grind 30/70 new bearings, conrods resized, new bolts, new gudgeon pins, rods shot peened and balanced, new oil pump gears shaft and relief valve, lightened flywheel & surface ground, new timing gears, refaced cam followers, engine fully balanced. New pressure plate and clutch plate, Head 1 ¾” inlets & 1 ½” exhausts, Chev valve springs, seals, std. comp. ratio, 2/71 GM blower fully reconditioned in excellent condition, 2” SU fully reconditioned.

my crankshaft has a roller bearing instead of a spigot bush, can anyone tell me what model had this and if they can be still purchased? regards jim

trevor B, received info thanks very much, regards jim

I would like the instructions  , thanks for your help. regards jim

anyone know supplier of oil pump gears? regards jim

anyone know where to obtain oil pump gears? regards jimbo492

can anyone tell me the distance from rocker cover to bonnet? regards jimbo492