Messages

Thank you gentlemen .

Replacing cork Rocker Cover and Sideplate Gaskets ... What are people using when installing new gaskets  ?  ... Grease, sealant or nothing ?

Thanks Vern ... but please, what is a double lip seal ?

I'm re-fitting my timing cover and would like to know what is recommended  ... just the gasket, or gasket and goo, or just sealant, or a combination... what is best for a good seal?
Thanks in advance, Dave.

Front and rear springs are different according to the manual and are not interchangeable !

The perils of re-assembling years after dismantling ! Where did I put that part ?

Thanks Doc ... AN 6 then.

I am making up fuel lines for twin carbies ... 5, 6, 8 or 10 AN?

Thanks in advance.

Fibre, steel, alloy ???  What is recommended ?

What is the correct colour for a1956 Bosch Starter motor?

Thank you gentlemen ... I guess no underlay is necessary then ?

Recommencing installation of interior .. What are best options before fitting the new fitted carpet ?

Are members using sound deadening sheets, and if so, what type/ brand is recommended ?

...and as to underlay , what is recommended ?  I still have my old original fibre underlay ... what are members using ?

Are members using sound deadening sheets AS WELL AS underlay ?

Comments and advice appreciated ... Cheers, Davo.

Went to Pirtek , Port Macquarie and "Dean" sorted it all , no problem ... will be back there for sure ... also sorting hoses and fittings for twin cabs ... highly recommended .

Somehow I thought you'd have the answer Harv  ... thanks, Off to Pirtek/Enzed ... or perhaps pay $99 to E.B. ????!!!

Fitting remote oil filter and oil gauge ... need a Tee piece or two ... Mr Bitz has chromed for $99 and on Ebay they are up to $550 from Taiwan , WTF !!!!!!! Surely they are available here for only a few $$$ ....any info appreciated  ... also , what us the thread type (UNC) ? and diameter ...Cheers , Davo .

Thanks Nick ...see you this arv  ;) ;) ;)

Thank you Ken and Errol :)

Thanks Ken ... Perhaps I will restrict stainless to the "bling" chrome bits ... Are the bolts listed on the parts CD ?

Have re-re-re-recommenced putting the FE back together after 10 years plus and have decided to replace all bolts , pipes , pressure pipes etc , etc  (have misplaced many or donated some to my FJ) ... thinking of going mostly stainless ... any thoughts ?? Also , is there a listing of specs for all bolts on FE & FC ? ... ie ... UNC and/or UNF ... presumably all are imperial ?  Any advice will be appreciated ...

The Brock "05 Torana" will be attending ...