News:

Are you a member of one of the FE-FC Holden Car Clubs of Australia ? If you are, get access to the Club-Member-only area of this discussion board. Send an IM to the board admin, including your real name and club to get access.

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - captainkickback

Pages1
#1
General Technical / Re: Grey Motor Harmonic balancer removal tool thread size?
October 01, 2010, 11:01:22 PM
Thanks Rusty,
It looks like i'm heading to the workshop to knock a couple of these bad boys up right now...

Cheers.
#2
General Technical / Re: Grey Motor Harmonic balancer removal tool thread size?
October 01, 2010, 10:27:57 PM
Quote from: Maco on October 01, 2010, 08:18:35 PM
Hi CKB,

I have measured my removal tool and it measures 1.120" Diameter x 12 TPI. (1.1/8" 12 UNF)

Hope this helps.

John

That's Great.
Thanks to John and everyone who helped with this info.

Cheers,
Jamie.
#3
General Technical / Re: Grey Motor Harmonic balancer removal tool thread size?
October 01, 2010, 06:13:44 PM
Quote from: Maco on October 01, 2010, 08:07:00 AM
I can check the thread size tonight if that helps.

Cheers
John

That would be great.
Thanks John.
#4
General Technical / Re: Grey Motor Harmonic balancer removal tool thread size?
September 30, 2010, 10:27:44 PM
Thanks Rusty.
#5
General Technical / Grey Motor Harmonic balancer removal tool thread size?
September 29, 2010, 02:21:06 AM
Could anyone give me the thread size of the male thread that screws into the pulley?
My Dad lives up the Central Coast and is overhauling a friends grey motor and doesn't want to buy one for a "one off" job. I  can machine one up at work if i have the dimensions.
Any help will be appreciated.
Pages1