News:

Are you a member of one of the FE-FC Holden Car Clubs of Australia ? If you are, get access to the Club-Member-only area of this discussion board. Send an IM to the board admin, including your real name and club to get access.

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Phil Gray

#1
Cars For Sale / FE Special Sedan
May 15, 2003, 12:43:53 AM
Now asking just $7,500 for this immaculate vehicle.

Bare metal restoration, all mechanicals, rubber and trim in ex cond. Low miles.

For details and pics of this great car, see my website at  www.users.bigpond.net.au/flippnlorry/

Phil Gray, Sydney
02-9418 4586
Email: flippnlorry@yahoo.com
#2
Cars For Sale / Excellent FE Special Sedan
April 03, 2003, 09:03:13 PM
FOR SALE
Full bare metal restoration by 3rd owner (tho' it was in v.good registered condition before I started). All documentation and receipts available. 12 months reg'n. (FE 574; Chassis/build 13096S)

Genuine 105,000 miles, only about 2,500 miles on recond. motor, clutch and gearbox. All mechanicals, trim, rubber and accessories in excellent condition.

Accessories:
 Â  Genuine Holden blinkers
 Â  Recond. AIR CHIEF car radio
 Â  TRICO pump action windscreen washers
 Â  Spats (reproduction)
 Â  Gear lever lock  
 Â  Other bits unfitted, incl' taxi bar

Visit my website www.users.bigpond.com/pgray/ and click to "FE-FC Holden" and "MY FE Restoration" for photo album.

Reduced to $8,000 for quick sale - I need the garage.

Phil Gray, Sydney
flippnlorry@yahoo.com

#3
Restoration Help / Air Chief Radio  - Face Plate
November 04, 2002, 06:35:24 AM
I am trying to locate a faceplate for an Air Chief radio - that is, the black bakelite plate that fits around the radio face with a little "Air Chief" badge on the top front.

Somone told me that a guy called John Carr (Canberra disrict) may make reproductions, but I have been unable to get his contact details.   ::)

Any assistance in tracking him down would be appreciated.

Phil Gray
pgray@bigpond.com
#4
General Technical / CHROMING DIE-CAST
August 31, 2001, 07:29:21 AM
I had the headlight rims on my FE re-chromed about 5 years ago - a great job at the time, but alas, there are now bubbles appearing from under the chrome.

If I was to get them re-done, is there any special treatment that will stop the die-cast from bubbling?