- Welcome to FE-FC Holden Discussion Forum.
News:
Are you a member of one of the FE-FC Holden Car Clubs of Australia ? If you are, get access to the Club-Member-only area of this discussion board. Send an IM to the board admin, including your real name and club to get access.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
Project Cars - FEs and FCs Under Construction / Re: start of new project :)
May 19, 2009, 12:02:13 AM
#2
Project Cars - FEs and FCs Under Construction / Re: start of new project :)
May 18, 2009, 11:38:04 PM
as for mods all ready is ;D ie red motor 186
toyota 5 speed,diff pinion cover says 3.36 ratio hopefully true
hr disc brake front end and crs chassis kit
will post some more picts later
toyota 5 speed,diff pinion cover says 3.36 ratio hopefully true
hr disc brake front end and crs chassis kit
will post some more picts later
#3
Project Cars - FEs and FCs Under Construction / Re: start of new project :)
May 18, 2009, 11:30:36 PM
thanks for the welcome
had this for about 12 months pictures make it look better than it is
rust in floors /r/h rear lower quarter panel bogged over and lower inner a pillar
rusty ,have brother who has taught me how to tig weld should come in handy
had this for about 12 months pictures make it look better than it is
rust in floors /r/h rear lower quarter panel bogged over and lower inner a pillar
rusty ,have brother who has taught me how to tig weld should come in handy
#4
Project Cars - FEs and FCs Under Construction / start of new project :)
May 17, 2009, 11:39:48 PM
#5
General Technical / Re: Fuel Tank
April 26, 2009, 05:09:20 PM
should be able to use fe/fc sender as ohms for guage will be the same i think ?
Pages1